[1] The JOULE-II sounding rocket salvo was launched from Poker Flat Rocket Range into weak pulsating aurora following a moderate substorm at 0345 LT on 19 January 2007. We present in situ measurements of ion flow velocity and electric and magnetic fields combined with neutral wind observations derived from ground observations of in situ chemical tracers. Measured ion drifts in the 150-198 km and 92-105 km altitude ranges are consistent withẼ ÂB motion to within 16 m s À1 rms and with neutral wind velocity to within 20 m s À1 , respectively. From these measurements we have calculated the ratio k of the ion cyclotron and ion collision frequencies, finding k = 1 at an altitude of 118 ± 0.3 km. Using direct measurements of ion current, we calculate the Joule heating rate and Pedersen and Hall conductivity profiles for this moderately active event and find height-integrated values of 390 W km À2 and 0.59 and 2.22 S, respectively. We also find that these values would have errors of up to tens of percent without coincident neutral wind measurements, and presumably more so during more active conditions. Ion flow vectors were measured at a rate of 125 s

In this work, a temperature-sensitive conductive hybrid hydrogel is prepared by in situ polymerization on MWCNT reinforced PNIPAM/CMCS hydrogels. MWCNT and PANI combined the PNIPAM/CMCS matrix with physical and chemical crosslinking that improved the stiffness and elasticity of hydrogel. Due to good mechanical stretchability, high electrical conductivity, thermal responsiveness and pH sensitivity, this hydrogel has potential in the application of wearable devices, temperature sensitive sensor and pH detector. Polymer hydrogels with stimulus-response characteristics with good electrical properties have great potential in electrical, electrochemical, and biomedical devices. Here, a temperaturesensitive conductive hybrid hydrogel is prepared using in-situ polymerized polyaniline (PANI) on PNIPAM/CMCS/MWCNT hydrogel substrate. The network of physical and chemical crosslinking endows the PNIPAM/CMCS/MWCNT/PANI hydrogel with highly porous structures, which greatly enhances the mechanical properties and enhances the stability. The hybrid hydrogel as a strain sensor shows high sensitivity (gauge factor 3.603) and outstanding linear dependence of sensitivity on strain. The hybrid hydrogels can be used to construct highly sensitive temperature alertor based on circuit disconnection caused by volume shrinkage at high temperatures. Moreover, the hybrid hydrogels can also be used as pH sensor to monitor changes of acid and alkali in the solution.

No abstract

No abstract

No abstract