Mycotoxins are frequent contaminants of grains, and breweries need, therefore, to pay close attention to the risk of contamination in beer made from such grains as barley and corn. The fate of 14 types of mycotoxin (aflatoxins, fumonisins, ochratoxin A, patulin, trichothecenes, and zearalenone) during beer brewing was investigated in this study. Malt artificially spiked with each mycotoxin was put through the mashing, filtration, boiling and fermentation processes involved in brewing. After brewing, the levels of aflatoxins, ochratoxin A, patulin, and zearalenone were found to have decreased to less than 20% of their initial concentration. They had been adsorbed mainly to the spent grain and removed from the unhopped wort. Additionally, as zearalenone was known, patulin was metabolized to the less toxic compound during the fermentation process. The risk of carry-over to beer was therefore reduced for half of the mycotoxins studied. However, attention still needs to be paid to the risk of trichothecene contamination.

The fates of more than 300 pesticide residues were investigated in the course of beer brewing. Ground malt artificially contaminated with pesticides was brewed via steps such as mashing, boiling, and fermentation. Analytical samples were taken from wort, spent grain, and beer produced at certain key points in the brewing process. The samples were extracted and purified with the QuEChERS (Quick Easy Cheap Effective Rugged and Safe) method and were then analyzed by LC-MS/MS using a multiresidue method. In the results, a majority of pesticides showed a reduction in the unhopped wort and were adsorbed onto the spent grain after mashing. In addition, some pesticides diminished during the boiling and fermentation. This suggests that the reduction was caused mainly by adsorption, pyrolysis, and hydrolysis. After the entire process of brewing, the risks of contaminating beer with pesticides were reduced remarkably, and only a few pesticides remained without being removed or resolved.

Aflatoxin B1 (AFB1) is a contaminant of grain and fruit and has one of the highest levels of carcinogenicity of any natural toxin. AFB1 and the fungi that produce it can also contaminate the raw materials used for beer and wine manufacture, such as corn and grapes. Therefore, brewers must ensure strict monitoring to reduce the risk of contamination. In this study, the fate of AFB1 during the fermentation process was investigated using laboratory-scale bottom and top beer fermentation and wine fermentation. During fermentation, cool wort beer samples and wine must samples were artificially spiked with AFB1 and the levels of AFB1 remaining after fermentation were analyzed. AFB1 levels were unchanged during both types of fermentation used for beer but were reduced to 30% of their initial concentration in wine. Differential analysis of the spiked and unspiked wine samples showed that the degradation compound was AFB2a, a hydrated derivative of AFB1. Thus, the results showed that the risk of AFB1 carryover was still present for both types of beer fermentation but was reduced in the case of wine fermentation because of hydration.

Moromi (the fermented mash) of ''mugi shochu'' that had been artificially contaminated with pesticides was distilled to elucidate the fate of pesticides in the distillation process. The pesticides residing in the distillate were quantified by liquid chromatographytandem mass spectrometry (LC-MS/MS). Of the analyzed pesticides (249 compounds), 89% were not detected in the distillate, showing that the distillation process minimized the risk of pesticide contamination.

An LC-MS/MS method was developed for the simultaneous determination of 15 water-soluble vitamins that are widely used as additives in beverages and dietary supplements. This combined method involves the following simple pre-treatment procedures: dietary supplement samples were prepared by centrifugation and filtration after an extraction step, whereas beverage samples were diluted prior to injection. Chromatographic analysis in this method utilised a multi-mode ODS column, which provided reverse-phase, anion- and cation-exchange capacities, and therefore improved the retention of highly polar analytes such as water-soluble vitamins. Additionally, the multi-mode ODS column did not require adding ion pair reagents to the mobile phase. We optimised the chromatographic separation of 15 water-soluble vitamins by adjusting the mobile phase pH and the organic solvent. We also conducted an analysis of a NIST Standard Reference Material (SRM 3280 Multi-vitamin/Multi-element tablets) using this method to verify its accuracy. In addition, the method was applied to identify the vitamins in commercial beverages and dietary supplements. By comparing results with the label values and results obtained by official methods, it was concluded that the method could be used for quality control and to compose nutrition labels for vitamin-enriched products.