The machining of tungsten heavy alloy is very difficult as it has high strength and hardness, which requires special cutting tools and cutting process. Though carbide tools are extensively used in conventional cutting, these lead take high machining time and tool failures which cause to decrease in productivity. To overcome the above, special techniques are being practiced in machining of tungsten alloys, one such technique is machining under cryogenic environment. In this paper, liquid nitrogen is used as coolant in machining of tungsten heavy alloys, because it is cost effective, safe, non flammable and environmental friendly gas, in addition to that it cannot contaminate the work piece and no separate mechanism required for disposal. An experimental investigation has been carried out on machining of tungsten heavy alloys by the solid carbide cutting tools under cryogenic and conventional coolants. The material removal rate, surface integrity and cutting forces were studied for both the coolants. The chip morphology also measured for evaluation of shear stress and shear strain. The cryogenic coolant has enhanced the machinability of tungsten heavy alloys. It is observed that the material removal rate was three times higher in cryogenic cooling method when compared with conventional coolant method and the surface finish of the machined surfaces are extremely good and the magnitude of cutting forces are lesser in cryogenic coolant.

No abstract

No abstract

No abstract

No abstract