Size- and time-dependent particle removal efficiency (PRE) of different protective respiratory masks were determined using a standard aerosol powder with the size of particles in the range of an uncoated SARS-CoV-2 virus and small respiratory droplets. Number concentration of particles was measured by a scanning mobility particle sizer. Respiratory protective half-masks, surgical masks, and cotton washable masks were tested. The results show high filtration efficiency of FFP2, FFP3, and certified surgical masks for all sizes of tested particles, while protection efficiency of washable masks depends on their constituent fabrics. Measurements showed decreasing PRE of all masks over time due to transmission of nanoparticles through the mask-face interface. On the other hand, the PRE of the fabric is governed by deposition of the aerosols, consequently increasing the PRE.

No abstract

In this research, the influences of the addition of PVP to PVDF-HFP polymers and the preparation of thin films using a solvent casting method were studied. The PVDF-HFP and polymer blend PVDF-HFP/PVP thin films with a nanostructured surface were investigated using scanning electron microscopy, differential scanning calorimetry, nanoindentation, and dielectric spectroscopy. The results showed that the PVP formed a dispersed phase (the poorer conductive islands) in the PVDF-HFP polymer matrix, which reduced its mechanical properties. The crystallinity of PVDF-HFP polymer decreased with the addition of PVP by 7.4%, but the PVP induced the formation of the polar β-phase of PVDF-HFP. Therefore, an improved dielectric response is expected, but it was not significantly improved even though the polar β-phase was detected. The contrasting effect was attributed to less conductive PVP islands on the surface of the PVDF-HFP/PVP polymer blend, which decreased its conductivity.

No abstract