The nuclear fusion cross-section is modified when the spins of the interacting nuclei are polarized. In the case of deuterium-tritium it has been theoretically predicted that the nuclear fusion cross-section could be increased by a factor S = 1.5 if all the nuclei were polarized. In inertial confinement fusion this would result in a modification of the required ignition conditions. Using numerical simulations it is found that the required hot-spot temperature and areal density can both be reduced by about 15% for a fully polarized nuclear fuel. Moreover, numerical simulations of a directly driven capsule show that the required laser power and energy to achieve a high gain scale as 5~°6 and S~°A respectively, while the maximum achievable energy gain scales as 5° 9 .
We present a 2D analysis of direct-drive shock ignition for the laser Megajoule. First, a target design is chosen in the HiPER-like target family generated by scale up and down of the original HiPER target. A first analysis is done considering the 1D fuel assembly and 2D shock ignition by means of the ring at polar angle of 33°2. The intensity profile is top-hat and calculations are done for several different radii. It is shown that larger the radius, lower the minimum spike power is. In addition, the intensity in each quad can stay below 4 × 1014 W/cm2 and is considered non crucial for parametric instabilities such as two plasmons. A 2D analysis of the fuel assembly is done in a second step by considering the two rings located at 49° and 59°5 and their symmetric by the equatorial plane symmetry. It is shown that low mode asymmetries are important at the stagnation and can significantly affect the areal density obtained. Finally, full 2D calculations of shock ignition is done, using all the beams of the LMJ and show that the spike power needed for ignition and gain is increased by a factor greater than 3 regarding the power needed in perfectly isotropic fuel assembly. This increase is mainly due to high level low mode asymmetries generated during fuel assembly.
Analysis of low initial aspect ratio direct-drive target designs is carried out by varying the implosion velocity and the fuel mass. Starting from two different spherical targets with a given 300 /xg-DT mass, optimization of laser pulse and drive power allows to obtain a set of target seeds referenced by their peak implosion velocities and initial aspect ratio (A = 3 and A = 5). Self-ignition is achieved with higher implosion velocity for A = 5-design than for A = 3-design. Then, rescaling is done to extend the set of designs to a huge amount of mass, peak kinetic energies and peak areal densities. Self-ignition kinetic energy threshold Ek is characterized by a dependance of Ek ~ v& with ^S-values which depart from self-ignition models. Nevertheless, self-ignition energy is seen lower for smaller initial aspect ratio. An analysis of Two-Plasmons Decay threshold and Rayleigh-Taylor instability e-folding is carried out and it is shown that two-plasmon decay threshold is always overpassed for all designs. The hydrodynamic stability analysis is performed by embedded models to deal with linear and non-linear regime. It is found that the A = 5-designs are always at the limit of disruption of the shell.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Copyright © 2025 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.