No abstract

We present a new result for the wavelength-selective characteristics of a 1D photonic microcavity based on porous silicon. These properties are studied in both experimentation and simulation. The 1D Fabry–Perot cavity is fabricated by the electrochemical etching of a low-resistivity silicon wafer with modulation of applied current densities. The simulation relies on the transfer matrix method (TMM) to design and predict the optical properties of a 1D photonic microcavity as well as the relation between anodization parameters with reflection spectra. The experimental results show that the elaborated porous silicon photonic microcavities have the wavelength-selective property in a controllable range of 550–775 nm. We have grown cavity structures of 20 stacked layers and the line width at full-width half-maximum (FWHM) of the transmission band of cavity is 20 nm, centered at 643.27 nm. Measured spectral characteristics of photonic microcavity agree with the simulation results.

The necessity of environmental protection has stimulated the development of many kinds of methods allowing the determination of different pollutants in the natural environment, including methods for determining nitrate in source water. In this paper, the characteristics of an etched fiber Bragg grating (e-FBG) sensing probe—which integrated in fiber laser structure—are studied by numerical simulation and experiment. The proposed sensor is demonstrated for determination of the low nitrate concentration in a water environment. Experimental results show that this sensor could determine nitrate in water samples at a low concentration range of 0–80 ppm with good repeatability, rapid response, and average sensitivity of 3.5 × 10−3 nm/ppm with the detection limit of 3 ppm. The e-FBG sensing probe integrated in fiber laser demonstrates many advantages, such as a high resolution for wavelength shift identification, high optical signal-to-noise ratio (OSNR of 40 dB), narrow bandwidth of 0.02 nm that enhanced accuracy and precision of wavelength peak measurement, and capability for optical remote sensing. The obtained results suggested that the proposed e-FBG sensor has a large potential for the determination of low nitrate concentrations in water in outdoor field work.

In this paper we present a sensing method using nano-porous silicon microcavity sensor, which was developed in order to obtain simultaneous determination of two volatile substances with different solvent concentrations as well as very low pesticide concentration in water. The temperature of the solution and the velocity of the air stream flowing through the solution have been used to control the response of the sensor for different solvent solutions. We study the dependence of the cavity-resonant wavelength shift on solvent concentration, velocity of the airflow and solution temperature. The wavelength shift depends linearly on concentration and increases with solution temperature and velocity of the airflow. The dependence of the wavelength shift on the solution temperature in the measurement contains properties of the temperature dependence of the solvent vapor pressure, which characterizes each solvent. As a result, the dependence of the wavelength shift on the solution temperature discriminates between solutions of ethanol and acetone with different concentrations. This suggests a possibility for the simultaneous determination of the volatile substances and their concentrations. On the other hand, this method is able to detect the presence of atrazine pesticide by the shift of the resonant wavelength, with good sensitivity (0.3 nm pg −1 ml) and limit of detection (LOD) (0.8-1.4 pg ml −1 ), that we tested for concentrations in the range from 2.15 to 21.5 pg ml −1 , which is the range useful for monitoring acceptable water for human consumption.

Permethrin, 3-Phenoxybenzyl (1 RS)-cis,trans-3-(2,2-dichlorovinyl)- 2,2-dimethylcyclopropanecarboxylate, has a wide range of applications like insecticide, insect repellent and prevents mosquito-borne diseases, such as dengue fever and malaria in tropical areas. In this work, we develop a prominent monitoring method for the detection of permethrin pesticide using surface-enhanced Raman scattering (SERS) optical fibre substrates. The novel SERS-active optical fibre substrates were grown and deposited silver (Ag) nano-dendrites on the end of multi-mode fibre core by laser-assisted photochemical method. The characteristic of the Ag-nanostructures could be controlled by the experimental conditions, namely, laser illumination time. Ag nanoparticles optical fibre substrates and Ag nano-dendrites optical fibre substrates were prepared with laser illumination time of 3 min and 8 min, respectively. The achieved SERS-activity optical fibre substrates were tested with Rhodamine 6G aqueous solutions. We demonstrate that the SERS activity coupled with Ag nano-dendrites optical fibre substrate has higher Raman enhancement factor due to the creation of many of hot-spots for amplifying Raman signals. Besides, the stability and reproducibility of the Ag nano-dendrites optical fibre substrate were also evaluated with stored time of 1000 hours and relative standard deviation of less than 3%. The Ag nano-dendrite optical fibre substrate was selected for detection of permethrin pesticide in the concentration range of 0.1 ppm–20 ppm with limit of quantification (LOQ) of 0.1 ppm and calculated limit of detection (LOD) of 0.0035 ppm, proving its great potential for direct, rapid detection and monitoring of permethrin.