Objective: To study the shear bond strength (SBS), sites of failure, and micromorphology of bonded molar tubes used on teeth affected by dental fluorosis. Materials and Methods: This in vitro study included 140 first molars classified according to Dean's index for dental fluorosis. Samples were divided into seven groups: (1) healthy teeth etched for 15 seconds, (2) teeth with moderate fluorosis (MOF) etched for 15 seconds, (3) teeth with MOF etched for 150 seconds, (4) teeth with MOF microabrasion etched for 15 seconds, (5) teeth with severe fluorosis (SEF) etched for 15 seconds, (6) teeth with SEF etched for 150 seconds, and (7) teeth with SEF microabrasion etched for 15 seconds. All samples were incubated and were then submitted to the SBS test and evaluated with the modified adhesive remnant index (ARI) and analyzed by using a scanning electronic microscope. Results: The SBS mean value for healthy enamel was 20 6 10.2 MPa. For the group with MOF, the etched 150-second mean value was the highest (19 6 7.6 MPa); for the group with SEF treated with microabrasion and etched for 15 seconds, the mean value was (13 6 4.1 MPa). Significant differences (P # .05) were found in the ARI between healthy and fluorosed groups. Conclusions: Fluorotic enamel affects the adhesion of bonded molar tubes. The use of overetching in cases of MOF and the combination of microabrasion and etching in SEF provides a suitable adhesion for fixed appliance therapy. (Angle Orthod. 2013;83:152-157.)

) were obtained to analyze structural differences among the specimens. Although the differences were not statistically significant (P > 0.05), the mean of integral areas of ν 1 phosphate peak among groups indicated greater mineralization in the severe fluorosis group. However, there were statistically significant differences in the intensities, and the integral areas of B-type carbonate peak among groups (P < 0.05). Therefore, mineralization of the carbonate peak at 1070 cm −1 decreased significantly in fluorotic groups, suggesting that carbonate ions are easily dissolved in the presence of fluoride. Although structurally fluorotic teeth are not more susceptible to dental caries, serious alteration in its surface topography may cause retention of bacterial plaque and formation of enamel caries. Micro-Raman spectroscopy is a useful tool for analyzing the molecular structure of healthy and fluorotic human enamel. (J Oral Sci 54, 93-98, 2012)

The aim was to compare the enamel surface roughness (ESR) and absolute depth profile (ADP) (mean peak-to-valley height) by atomic force microscopy (AFM) before and after using four different phosphoric acids. A total of 160 enamel samples from 40 upper premolars were prepared. The inclusion criterion was that the teeth have healthy enamel. Exclusion criteria included any of the following conditions: facial restorations, caries lesions, enamel hypoplasia and dental fluorosis. Evaluations of the ESR and ADP were carried out by AFM. The Mann-Whitney U-test was used to compare continuous variables and the Wilcoxon test was used to analyze the differences between before and after etching. There were statistically significant differences (P

Aim: To compare the type, number of procedures and working time of dental treatment provided under dental general anesthesia (DGA) in healthy and medically compromised/developmentally disabled children(MCDD children). Design: This cross-sectional prospective study involved 80 children divided into two groups of 40 children each. Group 1 consisted of healthy and Group 2 consisted of MCDD children. Results:Healthy children needed more working time than MCDD children, the means being 161±7.9 and 84±5.7 minutes, respectively (P= 0.0001). Operative dentistry and endodontic treatments showed a significant statistical difference (P= 0.0001). The means of procedures were 17±5.0 for healthy children and 11±4.8 for MCDD children (P= 0.0001). Conclusions: Healthy children needed more extensive dental treatment than MCDD children under DGA. The information from this sample of Mexican children could be used as reference for determining trends both within a facility as well as in comparing facilities in cross-population studies.

The provision of comprehensive care for patients with special needs using dental general anesthesia (DGA) has changed over time, and now includes more complex procedures and the participation of many services. As a result, it is necessary to integrate, organize and describe all of the procedures that are carried out in different DGA settings. The aim of this study was to propose a systematic classification for dental treatment procedures be delivered under DGA, and to compare this classification system with an existing system. This new classification system has three distinct components: type, frequency and length of time needed to complete dental procedures for both primary and permanent teeth. A wide range of oral surgery procedures and endodontic treatment was also included. A retrospective cohort study utilizing 84 subjects was used to develop and compare the two classification systems. When comparing the different categories of procedures by both classifications, there were significant statistical differences between them (p < 0.05). Oral health care for patients with special needs has evolved, with more complex and extensive interventions that require teamwork by personnel from different dental or medical specialties. The classification system in this study includes detailed information regarding the procedures involved in the DGA. This helps to provide a clear understanding and specific information that enables the comparison of clinical experiences across populations where a DGA has been used for patients with special needs.