This paper reports the use of polysaccharides extracted from seed of Persea americana var. Hass in the synthesis of acrylic hydrogels. The effects of the chemical composition (acrylamide/acrylic acid), the concentration of crosslinking agent (glycerol diacrylate) and the type of initiation (redox, photoinitiation) of the hydrogels were evaluated with and without polysaccharides. Xerogels were characterized by FTIR spectroscopy, differential scanning calorimetry (DSC) and scanning electron microscopy (SEM), while for the swollen hydrogels the swelling kinetic and mechanical properties were evaluated. The kinetic parameters were obtained using the second order equation proposed by Schott, where it is reported that by increasing the concentration of the crosslinking agent, the degree of swelling is reduced because of the greater structural level. The increase of the amount of acrylamide and the amount of polysaccharides causes also a decrease in the swelling degree. The type of initiation also affected the hydrogels swelling kinetic, the photoinitiated hydrogels were the ones that captured less water. Moreover, the increasing of the glass transition temperature and the compression modulus with the crosslinking agent concentration and molar ratio AAm/AAc are observed for hydrogels with and without polysaccharides. The results demonstrate a successful incorporation of polysaccharides into the polymeric network.

Several methods to measure surface tension involve some inconveniences when applied to moderate or highly viscous polymer solutions. Therefore, an improved version of the weight drop method (WDM) is proposed here. In addition, a comparative analysis of methods is carried out, including the drop profile (DPM), the selected planes (SPM), the WDM and the one proposed here (WDSM), finding that the WDSM is as easy to apply as the SPM and the WDM, although in practical conditions it is much more accurate than either of them. Moreover, the WDSM allows to reproduce the results that can be obtained using DPM, but, in general, it is much easier to implement and apply than such method. The WDSM was used to determine surface tension in polystyrene or poly(methyl methacrylate) in styrene solutions, where the dependence of such property with polymer average molecular weight and polymer concentration was experimentally evaluated.