The article deals with the question of the effect of explosive characteristics of emulsion explosives on the shotpile width. Currently, there are two main points of view to select an efficient type of explosive, which contributes to the qualitative destruction (fragmentation) of coarse clastic rocks. The first is based on the assumption that the detonation velocity of explosives must correspond to the break-down point of the rock (dynamic compression). Another point of view is that the detonation pressure of explosives determines only the head part of the pulse, on which the rock fragmentation is dependent only near the charge, in the contact zone around the borehole. The fragmentation of the entire rock volume within a given borehole array depends on the total magnitude of the explosion pulse, determined not by the detonation velocity, but by the total energy reserve of the explosive charge. Experimental explosions with some of the most common industrial explosives have been carried out in the current conditions of blasting of borehole charges by various types of industrial explosives from the point of view to select the most important parameter, which determines its influence on the shotpile width The investigations have been carried out according to the data obtained to establish that the energy properties of explosives (heat of explosive transformation and density of explosives) determine the decisive influence on the shotpile width, and the operability, the volume of the released gases, the detonation velocity for the change in the shotpile width have very little effect and may not be taken into account in calculations for the prediction of the shotpile.

As the depth of mining increases, attention to the preservation of mine workings and mining blasting is steadily growing. Technological methods of effective mineral development are often limited by dynamic blasting impact causing short-period fluctuations in the rock mass. Therefore, correct explosion impact identification, to a great extent, determines effective mining trends. Some results of researches for minimum blasting impact on mining workings are given in the article. Calculation of safe distances and excess pressure at shock air impact of technological explosions on the Magnezitovaya mine personnel was made. The calculation was made for the 15.5 m mine working section, with two conditions of the total section of the mine workings adjacent to the face of 15.5 m and 31 m with distances of 50 m and 100 m. Overpressure was also calculated for a total cross-section of 15.5 m and distances of 150 and 200 m. It was determined that the safe distance for people under overpressure conditions at the shock air wave front, depending on breaking schemes, is in the range of 150-200 m. The urgency of this research is to ensure industrial safety of underground mining operations.

No abstract