No abstract

No abstract

This paper illustrates the different possibilities given by additive manufacturing technologies for the creation of passive microwave hardware. The paper more specifically highlights a prototyping scheme where the 3D-printed plastic parts can be used as initial proofs of concept before considering more advanced 3D-printed parts (metal parts, for instance). First, a characterization campaign has been made on common plastics used by a 3D printer using the fused deposition modeling and material jetting (Polyjet©) technologies. The impact of the manufacturing strategy (high-speed or high-accuracy) on the part roughness, as well as on the dielectric material permittivity and loss tangent, has been specifically studied at 10 and 16 GHz. Based on a specifically optimized and deeply explained characterization method, the conductivity of a coating based on silver paint has also been characterized on such plastic parts at 10 and 40 GHz. These plastic materials and coating have been used for the creation of quasi-elliptic and tuning-free bandpass filters centered at 6 and 12 GHz and compared with a similar filter made of stainless steel by selective laser melting. Finally, a compact rectangularTE10to circularTE01mode converter also undergoes one prototyping step out of plastic before moving to an advanced part made out of stainless steel. This mode converter, which is made in a single part, is designed to operate from 28 to 36 GHz as a tuning-free final demonstrator.

A study on the passive microwave components made by polymer additive manufacturing (polymer jetting) is presented. Different types of components (waveguides, couplers, power dividers, filters and antennas) are designed to be made in a single part. Using a simple and cost‐effective metallisation by applying silver paint, various prototypes with complex geometries have been manufactured to evaluate these proofs of concept and the robustness of the low‐cost approach to make microwave components. Different measurements show that the obtained filters can provide an acceptable unloaded Q factor of 400–500 for the operating frequencies of 12–22 GHz. Waveguiding structures such as a mode converter, which is used as a broadband antenna, have also notably efficiently worked up to the Ka band (36 GHz). Due to a remarkable accuracy of nearly 80 µm, the obtained results of the proposed coupler, power divider and antennas are consistent with the full wave simulations, which prove that the currently available three‐dimensional plastic printers can provide notably accurate prototypes to design original components.