The objective of this study was to investigate the fate and removal of triclosan (TCS; 5-chloro-2-[2,4-dichloro-phenoxy]-phenol), an antimicrobial agent used in a variety of household and personal-care products, in wastewater treatment systems. This objective was accomplished by monitoring the environmental concentrations of TCS, higher chlorinated derivatives of TCS (4,5-dichloro-2-[2,4-dichloro-phenoxy]-phenol [tetra II]; 5,6-dichloro-2-[2,4-dichloro-phenoxy]-phenol [tetra III]; and 4,5,6-trichloro-2-(2,4-dichloro-phenoxy)-phenol [penta]), and a potential biotransformation by-product of TCS (5-chloro-2-[2,4-dicholoro-phenoxy]-anisole [TCS-OMe]) during wastewater treatment. These analytes were isolated from wastewater by using a C18 solid-phase extraction column and from sludge with supercritical fluid CO2. Once the analytes were isolated, they were derivatized to form trimethylsilylethers before quantitation by gas chromatography-mass spectrometry. Recovery of TCS from laboratory-spiked wastewater samples ranged from 79 to 88% for influent, 36 to 87% for final effluent, and 70 to 109% for primary sludge. Field concentrations of TCS in influent wastewater ranged from 3.8 to 16.6 microg/L and concentrations for final effluent ranged from 0.2 to 2.7 microg/L. Removal of TCS by activated-sludge treatment was approximately 96%, whereas removal by trickling-filter treatment ranged from 58 to 86%. The higher chlorinated tetra-II, tetra-III, and penta closans were below quantitation in all of the final effluent samples, except for one sampling event. Digested sludge concentrations of TCS ranged from 0.5 to 15.6 microg/g (dry wt), where the lowest value was from an aerobic digestion process and the highest value was from an anaerobic digestion process. Analysis of these results suggests that TCS is readily biodegradable under aerobic conditions, but not under anaerobic conditions. The higher chlorinated closans were near or below the limit of quantitation in all of the digested sludge samples. Based on results from this study, the chlorinated analogues and biotransformation by-product of TCS are expected to be very low in receiving waters and sludge-amended soils.

The objective of this study was to investigate the fate and removal of triclosan (TCS; 5-chloro-2-[2,4-dichloro-phenoxy]-phenol), an antimicrobial agent used in a variety of household and personal-care products, in wastewater treatment systems. This objective was accomplished by monitoring the environmental concentrations of TCS, higher chlorinated derivatives of TCS (4,5-dichloro-2-[2,4-dichloro-phenoxy]-phenol [tetra II]; 5,6-dichloro-2-[2,4-dichloro-phenoxy]-phenol [tetra III]; and 4,5,6-trichloro-2-(2,4-dichloro-phenoxy)-phenol [penta]), and a potential biotransformation by-product of TCS (5-chloro-2-[2,4-dicholoro-phenoxy]-anisole [TCS-OMe]) during wastewater treatment. These analytes were isolated from wastewater by using a C18 solid-phase extraction column and from sludge with supercritical fluid CO2. Once the analytes were isolated, they were derivatized to form trimethylsilylethers before quantitation by gas chromatography-mass spectrometry. Recovery of TCS from laboratory-spiked wastewater samples ranged from 79 to 88% for influent, 36 to 87% for final effluent, and 70 to 109% for primary sludge. Field concentrations of TCS in influent wastewater ranged from 3.8 to 16.6 microg/L and concentrations for final effluent ranged from 0.2 to 2.7 microg/L. Removal of TCS by activated-sludge treatment was approximately 96%, whereas removal by trickling-filter treatment ranged from 58 to 86%. The higher chlorinated tetra-II, tetra-III, and penta closans were below quantitation in all of the final effluent samples, except for one sampling event. Digested sludge concentrations of TCS ranged from 0.5 to 15.6 microg/g (dry wt), where the lowest value was from an aerobic digestion process and the highest value was from an anaerobic digestion process. Analysis of these results suggests that TCS is readily biodegradable under aerobic conditions, but not under anaerobic conditions. The higher chlorinated closans were near or below the limit of quantitation in all of the digested sludge samples. Based on results from this study, the chlorinated analogues and biotransformation by-product of TCS are expected to be very low in receiving waters and sludge-amended soils.

No abstract

The concentrations and removals of 16 fragrance materials (EMs) were measured in 17 U.S. and European wastewater treatment plants between 1997 and 2000 and were compared to predicted values. The average FM profile and concentrations in U.S. and European influent were similar. The average FM profile in primary effluent was similar to the average influent profile; however, the concentration of FMs was reduced by 14.6-50.6% in primary effluent. The average FM profile in final effluent was significantly different from the primary effluent profile and was a function of the design of the wastewater treatment plant. In general, the removal of sorptive, nonbiodegradable FMs was correlated with the removal of total suspended solids in the plant, while the removal of nonsorptive, biodegradable FMs was correlated with 5-day Biological Oxidation Demand removal in the plant. The overall plant removal (primary + secondary treatment) of FMs ranged from 87.8 to 99.9% for activated sludge plants, 58.6-99.8% for carousel plants, 88.9-99.9% for oxidation ditch plants, 71.3-98.6% for trickling filter plants, 80.8-99.9% for a rotating biological contactor plant, and 96.7-99.9% for lagoons. The average concentration of FMs in final effluent ranged from the limit of quantitation (1-3 ng/L) to 8 microg/L. Measured FM removal and concentrations were compared to predicted values, which were based on industry volume, per capita water use, octanol-water partition coefficient, and biodegradability.

An analytical method was developed and used to measure trace levels of fragrance materials (FMs) in municipal wastewater and treated wastewater. Sixteen FMs were selected as analytes because of their wide range of physical chemical properties. The analytical method included the use of nine perdeuterated FMs as internal standards, a highflow C 18 speed disk for the extraction of FMs from aqueous matrices, and an accelerated solvent extraction system for the extraction of FMs from solid matrices. For aqueous matrices, average FM recoveries (relative to the perdeuterated FM internal standard) were 97-115%, with limits of quantitation ranging from 0.5 to 35 ng/L. For activated sludge solids and primary influent solids, the average FM recovery from the extraction procedure was 81%. Concentrations and removal of FMs at an activated sludge and a trickling filter wastewater treatment plant were determined in the U.S. FM influent concentrations ranged from 0.3 to 154 µg/L, while FM effluent concentrations ranged from 0.005 to 1.7 µg/L. FM removal, following secondary treatment, ranged from 80 to 99.9%, depending on the type of treatment and the fragrance material physical chemical properties and biodegradability. In general, the activated sludge plant had higher removals of FMs than the trickling filter plant. Although acceptable environmental risk assessments have been developed for several of these FMs, these and future environmental risk assessments can be refined and improved using this analytical method.