Organic solar cells (OSCs) based on non-fullerene acceptors (NFAs) have developed very fast in recent years. A proper balance among power conversion efficiency (PCE), stability, and production cost needs further elaboration. Here we investigate the industrial viability of highly efficient OSCs based on several representative NFAs. The most stable OSCs exhibit PCE of $8% along with extrapolated T 80 lifetime (80% of the initial PCE) of over 11,000 hr under equivalent 1 sun illumination, which would lead to a very impressive operational lifetime approaching 10 years. Photo-stability is strongly dependent on the end-group and side-chain engineering of the NFAs. Breaking of conjugation during photo-aging leads to increased energetic traps. Fluorination of the end-group stabilizes molecules against light soaking, while adding methyl groups shows an opposite trend. Side-chain modification can significantly influence the morphological stability. Reducing synthetic complexity of this class of NFAs will ultimately push the organic photovoltaics technology into real-life applications.

As the power conversion efficiency (PCE) of organic solar cells (OSCs)has surpassed the 17% baseline, the long-term stability of highly efficient OSCs is essential for the practical application of this photovoltaic technology. Here, the photostability and possible degradation mechanisms of three state-of-the-art polymer donors with a commonly used nonfullerene acceptor (NFA), IT-4F, are investigated. The active-layer materials show excellent intrinsic photostability. The initial morphology, in particular the mixed region, causes degradation predominantly in the fill factor (FF) under illumination. Electron traps are formed due to the reorganization of polymers and diffusion-limited aggregation of NFAs to assemble small isolated acceptor domains under illumination. These electron traps lead to losses mainly in FF, which is in contradistinction to the degradation mechanisms observed for fullerene-based OSCs. Control of the composition of NFAs close to the thermodynamic equilibrium limit while keeping adequate electron percolation and improving the initial polymer and NFA ordering are of the essence to stabilize the FF in NFA-based solar cells, which may be the key tactics to develop next-generation OSCs with high efficiency as well as excellent stability.

There is a strong market driven need for processing organic photovoltaics from eco-friendly solvents. Water-dispersed organic semiconducting nanoparticles (NPs) satisfy these premises convincingly. However, the necessity of surfactants, which are inevitable for stabilizing NPs, is a major obstacle towards realizing competitive power conversion efficiencies for water-processed devices. Here, we report on a concept for minimizing the adverse impact of surfactants on solar cell performance. A poloxamer facilitates the purification of organic semiconducting NPs through stripping excess surfactants from aqueous dispersion. The use of surfactant-stripped NPs based on poly(3-hexylthiophene) / non-fullerene acceptor leads to a device efficiency and stability comparable to the one from devices processed by halogenated solvents. A record efficiency of 7.5% is achieved for NP devices based on a low-band gap polymer system. This elegant approach opens an avenue that future organic photovoltaics processing may be indeed based on non-toxic water-based nanoparticle inks.

Phase stabilizers identified from a top-down strategy overcome microstructure instability of organic solar cells induced by thermal or photo stress.

No abstract