To explore the purification effect of biochar-constructed wetlands on rural domestic sewage, six types of biochar-constructed wetlands were constructed for experiments. Under different hydraulic conditions, the removal effects of each biochar-constructed wetland on chemical oxygen demand, ammonia nitrogen, total nitrogen, and total phosphorus in sewage were analyzed. The results showed that the removal rates of the four types of pollutants in each biochar-constructed wetland first increased and then decreased with the increase in hydraulic retention time, and the optimal hydraulic retention time range was 36–48 h. The highest removal rates of chemical oxygen demand, ammonia nitrogen, total nitrogen, and total phosphorus in the wetland were 97.34 ± 0.84%, 95.44 ± 1.29%, 98.95 ± 0.52%, and 97.78 ± 0.91%, respectively. The chemical oxygen demand (COD) removal rate of each biochar-constructed wetland increased first, then decreased with the increase in hydraulic load, and the optimal hydraulic load was 10 cm/d. The removal efficiency of ammonia nitrogen, total nitrogen, and total phosphorus of each biochar-constructed wetland gradually weakened with the increase in hydraulic load, and the optimal hydraulic load range was between 5 and 10 cm/d. Under these conditions, the highest removal rates of chemical oxygen demand, ammonia nitrogen, total nitrogen, and total phosphorus in the wetland were 92.15 ± 2.39%, 98.32 ± 0.48%, 96.69 ± 1.26%, and 92.62 ± 2.92%, respectively. Coconut shell and shell-constructed wetlands with the highest proportion of biochar in the matrix have the best removal effect on pollutants under different hydraulic conditions, and the wastewater purification effect is stronger, indicating that the addition of biochar is helpful for the removal of pollutants in constructed wetlands.

No abstract

The water body inside the constructed wetland is affected by various factors, and the flow state is relatively complicated. There will always be a certain degree of low velocity area and rapid outflow phenomenon, which makes part of the space in the wetland unable to be effectively used. Based on Computational Fluid Dynamics (CFD) technology, this paper uses Fluent's porous media model and discrete phase model to establish a hydrodynamic model of up and down baffled subsurface flow constructed wetland system. The internal flow field of the wetland is simulated, and the hydraulic performance of different baffle settings and substrate laying methods in the wetland is systematically evaluated. The results show that: up and down baffled subsurface flow constructed, with the same number of baffles, the hydraulic efficiency of the first baffle at the lower part of the substrate will be greater. Compared with the position of the baffle, the increase in the number of baffles does not significantly improve the hydraulic efficiency of the constructed wetland. The substrate layer thickness ratio has a significant effect on the two parameters of the variance of the hydraulic residence time distribution (σ2) and the flow divergence (σ02). By increasing the thickness of the middle substrate, the low flow rate phenomenon caused by the small porosity substrate area of the upper layer and the rapid outflow phenomenon of the lower substrate can be improved to a certain extent, the utilization efficiency of the middle substrate layer is improved, and the hydraulic performance is increased. The research results are of great significance for improving the utilization of wetland space and ensuring its efficient decontamination and purification function.