To ensure driving safety and cost effectively preserve pavements, unlike the traditional grooving, cutting joints, highway tunnels used micromilling resurfacing method to improve the skid resistance of concrete pavement. The Sensor Measured Texture Depth (SMTD) has been established for quantitatively evaluating micromilled surface quality. This paper explores the possibility of using three-dimensional (3D) line laser imaging technology to obtain the "full lane" elevation data of the pavement, then through the calculation of the index SMTD, construct a road surface spatial and temporal deterioration model, and provide quality control covering the whole lane, and identify the problem areas. The results show that the road wear condition gradually worsens with the increase in opening time, after 24 months, the proportion of the good level (> 0.55mm) of the three cells is 70.5%, 75.1%, and 70.2%. Analysis of the test data for three cells revealed that the tunnel pavement shows canalization in wear. The most severely abraded section is offset by 200-300 mm toward the roadway median compared to the theoretical vehicle wheel track zone. Subsequent studies can expand the experimental conditions and consider more influencing factors to study further the texture deterioration of the micromilled pavement.

In the context of the global pandemic of COVID-19, the use and disposal of medical masks have created a series of ethical and environmental issues. The purpose of this paper is to study and evaluate the high temperature properties and thermal storage stability of discarded-mask (DM)-modified asphalt from a multi-scale perspective using molecular dynamics (MD) simulation and experimental methods. A series of tests was conducted to evaluate the physical, rheological, thermal storage stability and microscopic properties of the samples. These tests include softening point, rotational viscosity, dynamic shear rheology (DSR), Fourier transform infrared (FT-IR) spectroscopy and molecular dynamics simulation. The results showed that the DM modifier could improve the softening point, rotational viscosity and rutting factor of the asphalt. After thermal storage, the DM-modified asphalt produced segregation. The difference in the softening point between the top and bottom of the sample increased from 2.2 °C to 17.1 °C when the DM modifier admixture was increased from 1% to 4%. FT-IR test results showed that the main component of the DM modifier was polypropylene, and the DM-modified asphalt was mainly a physical co-blending process. MD simulation results show that the DM modifier can increase the cohesive energy density (CED) and reduce the fractional free volume (FFV) of asphalt and reduce the binding energy between base asphalt and DM modifier. Multi-scale characterization reveals that DM modifiers can improve the high temperature performance and reduce the thermal storage stability of asphalt. It is noteworthy that both macroscopic tests and microscopic simulations show that 1% is an acceptable dosage level.

The objective of this paper is to study the reliability of 3D laser detection technology data density to crack width detection results of the cement slab. 4 groups of cement concrete crack elevation data with a laser data density of 0.5-1.5mm were obtained by an indoor 3D laser detection system, and 3D models were established. The nonlinear least square method was used to fit the fracture section and the crack width was determined by peak value analysis. The results show that: the lateral spacing of laser points has a large influence on the mean and discrete degree of cement concrete crack width detection results; the laser point spacing is positively correlated with the crack identification error. Insufficient laser accuracy leads to an overestimation of crack severity level and affects the accuracy of pavement damage condition evaluation; high-precision laser equipment has certain reliability for detecting cement concrete crack width above 3 mm. In the actual pavement crack width detection, the appropriate transverse spacing of laser points can be selected according to different error limit requirements to meet the requirements of both detection reliability and data processing efficiency. Suggestions for future research include expanding the experimental conditions, increasing the 3D laser point spacings, and selecting more road lanes and pavement materials to study further the influential factors of pavement crack width measurement.