An integrated model is proposed for involute gear pair combining the mixed elastodhydrodynamic lubrication (EHL) theory for finite line contact with surface temperature rise equations considering tribo-dynamic loading behaviors. The film stiffness and viscous damping as well as the friction force are taken into account. The surface topography of tooth flank measured by 3D surface profiler is also included to solve the local temperature and pressure distribution in the contact area. The results show that the temperature distributions in different meshing positions along the line of action exhibit dissimilar characteristics due to the varying of dynamic load and the changing slip-to-roll ratio, which denotes the relationship between sliding velocity and rolling velocity on the tooth flank. Besides, the maximum of temperature is likely to appear at different sides of the gear tooth width as the gear pair meshes along the line of action. Moreover, with the increasing surface roughness, the ratio of asperity contacts becomes larger, so more heat generates from the contact area and leads to higher temperature rise.

An integrated model for gear pair that combines the dynamic load with the mixed elasto-hydrodynamic lubrication (EHL) theory is proposed in this paper covering the film squeeze effect as well as the friction force generated from the rough surfaces. Compari-sons between the two models of load which are, respectively, based on minimum elastic potential energy (MEPE) criterion and dynamic motion equations built up in this paper are discussed. The results show that at low speed the loads calculated by the two models are similar. However, with increasing speed, the load exhibits dynamic characteristics gradually and reaches the highest value at resonant speed. Besides, the effects of the helix angle and the lubricant viscosity are also analyzed. Increasing the ambient viscosity could intensify the film stiffness and viscous damping. Gear with larger helix angle could weaken the impact phenomenon at the shift points where one tooth-pair disengages. Moreover, it is symmetric with regard to the pressure and film thickness across the face width for spur gear. Differently, the pressure for helical gear has a higher value at the dedendum of pinion where the film becomes thinner. In addition, speeding up the pinion would generally result in higher dynamic load and film pressure but thicker film thickness. [DOI: 10.1115/1.4007842]