A numerical and experimental study of plasma jet propagation in a low-temperature, atmospheric-pressure, helium jet in ambient air is presented. A self-consistent, multi-species, two-dimensional axially symmetric plasma model with detailed finite-rate chemistry of helium-air mixture composition is used to provide insights into the propagation of the plasma jet. The obtained simulation results suggest that the sheath forms near the dielectric tube inner surface and shields the plasma channel from the tube surface. The strong electric field at the edge of the dielectric field enhances the ionization in the air mixing layer; therefore, the streamer head becomes ring-shaped when the streamer runs out of the tube. The avalanche-to-streamer transition is the main mechanism of streamer advancement. Penning ionization dominates the ionization reactions and increases the electrical conductivity of the plasma channel. The simulation results are supported by experimental observations under similar discharge conditions.

The propagation behavior of cold atmospheric pressure plasma jets has recently attracted lots of attention. In this paper, a cold He plasma jet generated by a single plasma electrode jet device is studied. The spatial-temporal resolved optical emission spectroscopy measurements are presented. It is found that the emission intensity of the He 706.5 nm line of the plasma behaves similarly both inside the syringe and in the surrounding air (plasma plume). It decreases monotonously, which is different from the emission lines, such as N2 337.1 nm line, N2+ 391.4 nm line, and O 777.3 nm line. For the discharge inside the syringe, the emission intensity of the He 706.5 nm line decays more rapidly than that of the other three spectral lines mentioned above. The N2 337.1 nm line behaves a similar time evolution with the discharge current. For the N2+ 391.4 nm line and the atomic O 777.3 nm line, both of them decay slower than that of the He 706.5 nm and the N2 337.1 nm. When the plasma plume propagates further away from the nozzle, the temporal behaviors of the emission intensities of the four lines tend to be similar gradually. Besides, it is found that, when the size of the plasma bullet appears biggest, the propagation velocity of the bullet achieves its highest value while the emission intensity of the N2+ 391.4 nm line reaches its maximum. Detailed analysis shows that the Penning effect between the metastable state Hem and the air molecules may play a significant role in the propagation of the plasma bullet in the open air.

The fundamental of the generation and propagation of the atmospheric pressure nonequilibrium plasma jets has recently attracted significant interests. In this paper, investigations on the effects of the parameters of the pulsed dc voltages on the optical emission intensity of the plasma jet and the bullet propagation behavior are carried out based on the temporal-spatial resolved optical emission spectroscopy measurements and the high-speed photography. It is found that, with the increase in the applied voltage, the bullet propagates out from the nozzle earlier and accelerates to higher peak-velocities. The increase in the pulse frequency exerts no significant influences on the optical emission of the plasma jet and the bullet propagation velocity. But it can induce the bullet propagates out from the nozzle earlier. Besides, it is interesting to notice that, with the increase in the pulse width in the beginning, the bullet propagates out from the nozzle with longer delay time. However, when the pulse width is increased to be more than 100 μs, the delay time of the bullet propagating out from the nozzle becomes much shorter. On the other hand, with the increase in the pulse width, the optical emission intensity of the plasma jet drops and the maximum bullet velocity decreases too. Detailed analysis shows that it may be due to the accumulation of the charges and radicals, which can shorten the prebreakdown of the discharge inside the syringe and result in the bullet propagating out earlier from the nozzle.

In order to maximize the O concentration generated by the atmospheric pressure plasma jets (APPJs), several different methods of adding O2 additive to working gas have been proposed. However, it is not clear, which method is capable of generating the highest concentration of O atom. In this paper, the concentration of O atoms in an APPJs by adding O2 to (1) the working gas, to (2) the downstream inside the tube, and (3) to the shielding gas is investigated by two-photon absorption laser-induced fluorescence spectrometry. The results clearly demonstrate that the highest O density is achieved when 1.5% of O2 is added to the working gas rather than the other two methods. In other words, the most effective way to generate O atoms is by premixing O2 with the working gas. Further investigation suggests that O atoms are mainly generated around the electrode region, where the electric field is highest. In addition, when O2 is added to the working gas, if in the meantime extra O2 is added to the downstream inside the tube, a significant decrease of O density is observed.

A finite model based on the classical laminated plate theory is presented for the unimorph piezoelectric cantilever. The formulations of static and dynamic analysis are derived from the variation principle. Three material parameter matrices of the PZT are taken into account in the present model. The static analysis of the piezoelectric cantilever is performed to investigate the influence of the geometric parameters on the output voltage, and model analysis is selected to determine the natural frequency and eigenmodes. To validate the simulation results, an experiment on a unimorph cantilver with brass substrate was carried out. The experiment results were found to be in good agreement with the simulation results. The results indicate that the finite model can be beneficial to designing ideal piezoelectric energy harvesting devices.