A new ionization source based on microwave induced plasma was developed for ambient desorption/ionization. The microwave-induced plasma desorption/ionization source (MIPDI) was composed of a copper Surfatron microwave cavity where a fused-silica tube was centered axially. Stable nonlocal thermodynamic equilibrium plasma was generated in the quartz discharge tube when a microwave at a frequency of 2450 MHz was coupled to the microwave cavity. Analytes deposited on the surface of poly(tetrafluoroethylene) (PTFE) or quartz slide after hydrofluoric acid (HF) etching were desorbed and ionized by the plasma. The performance of the MIPDI technique was validated by the analysis of a variety of chemical substances, polymer compounds, and pharmaceutical drugs using argon or helium as the discharge gas. Protonated [M + H](+) or deprotonated [M - H](-) ions were observed in the positive or negative mode. MIPDI was also used for the analysis of compounds in a complex matrix without any sample preparation. MIPDI was also capable of analyzing liquid samples. The signal-to-noise ratio was 463 in the analysis of 9.2 ng of phenylalanine, and the limit of detection was 60 pg for phenylalanine. MIPDI could desorb and ionize analytes with a molecular weight of up to 1200, which was demonstrated by the analysis of polyethylene glycol 800 (PEG800). MIPDI has advantages of simple instrumentation, relatively high temperature, stability, and reproducibility.

Proton-transfer reaction mass spectrometry (PTR-MS) allows for real-time, on-line determination of absolute concentrations of volatile organic compounds (VOCs) with a high sensitivity and low detection limits (in the pptv range). The technique utilizes H₃O⁺ ions for proton-transfer reactions with many common VOCs while having little to no reaction with any constituents commonly present in air. Over the past decades, research has greatly improved the applications and instrumental design of PTR-MS. In this article, we give an overview of the development of PTR-MS in recent years and its application in medical research. The theory of PTR-MS and various methods for discriminating isobaric VOCs are also described. We also show several specialized designs of sample inlet system, some of those may make PTR-MS suitable for the detection of aqueous solution and/or non-volatile samples.

A novel ambient ionization technique for mass spectrometry, microfabricated glow discharge plasma (MFGDP), is reported. This device is made of a millimeter-sized ceramic cavity with two platinum electrodes positioned face-to-face. He or Ar plasma can be generated by a direct current voltage of several hundreds of volts requiring a total power below 4 W. The thermal plume temperature of the He plasma was measured and found to be between 25 and 80 °C at a normal discharge current. Gaseous, liquid, creamy, and solid samples with molecular weights up to 1.5 kDa could be examined in both positive and negative mode, giving limits of detection (LOD) at or below the fg/mm(2) level. The relative standard deviation (RSD) of manual sampling ranged from 10% to ~20%, while correlation coefficients of the working curve (R(2)) are all above 0.98 with the addition of internal standards. The ionization mechanisms are examed via both optical and mass spectrometry. Due to the low temperature characteristics of the microplasma, nonthermal momentum desorption is considered to dominate the desorption process.

In this study, antibody immobilization using a microwave-induced H2O/Ar plasma pretreatment was achieved for the first time. Plasma was used to activate the surface of a capillary-based immunosensor by increasing the density of silicon hydroxyls and dangling bonds to ensure better silanization. The capture antibodies were covalently immobilized after the silanized surface reacted with glutaraldehyde and antibodies. A Cy3-labeled detection antibody was used in combination with the antigen captured by the immunosensor to complete the sandwich-type immunoassay, and the signals were measured using a laser-induced fluorescence system. Microwave-induced H2O/Ar plasma pretreatment of the carcinoembryonic antigen (CEA) immunosensor improved the antibody immobilization, and there was an obvious improvement in the linear detection range, i.e., 1 order of magnitude compared with a commercial enzyme-linked immunosorbent assay (ELISA). This novel immobilization method dramatically improved the detection limit (0.5 pmol/L CEA) and sensitivity. Assay validation studies indicated that the correlation coefficient reached 0.9978, and the relative standard deviations were <7% for all samples, with recoveries of 99.7-107.1%. Furthermore, the immunosensor was applied successfully to CEA determination in actual saliva specimens with high sensitivity, acceptable precision, and reasonable accuracy. This enhanced CEA immunosensor based on microwave-induced H2O/Ar plasma was demonstrated to be a sensitive tool for CEA diagnostics.

No abstract