No abstract

Nano-and submicron-sized crystals are too small to contain inclusions and are, therefore, expected to have a higher internal quality compared to conventionally sized particles (several tens to hundreds of microns). Using electrospray crystallization, nano-and submicron-sized crystals can be easily produced. With the aid of electrospray crystallization, a mist of ultrafine solution droplets is generated and subsequent solvent evaporation leads to crystallization of submicron-sized crystals. Using cyclotrimethylene trinitramine (RDX) solutions in acetone, the conditions for a stable and continuous jet were established. At relatively small nozzle diameters and relatively low potential differences, hollow spheres of RDX crystals were observed. At a higher nozzle diameter and potential difference and in the region of a continuous jet, RDX crystals with an average size of around 400 nm could be produced. In order to test the quality of the submicron-sized energetic material, impact and friction sensitivity tests were carried out. The test results indicate that the submicron-sized product had reduced friction sensitivity, indicating a higher internal quality of the crystalline product.

Document VersionPublisher's PDF, also known as Version of Record (includes final page, issue and volume numbers) Please check the document version of this publication:• A submitted manuscript is the author's version of the article upon submission and before peer-review. There can be important differences between the submitted version and the official published version of record. People interested in the research are advised to contact the author for the final version of the publication, or visit the DOI to the publisher's website.• The final author version and the galley proof are versions of the publication after peer review.• The final published version features the final layout of the paper including the volume, issue and page numbers. Link to publication General rightsCopyright and moral rights for the publications made accessible in the public portal are retained by the authors and/or other copyright owners and it is a condition of accessing publications that users recognise and abide by the legal requirements associated with these rights.• Users may download and print one copy of any publication from the public portal for the purpose of private study or research.• You may not further distribute the material or use it for any profit-making activity or commercial gain • You may freely distribute the URL identifying the publication in the public portal ? Take down policyIf you believe that this document breaches copyright please contact us providing details, and we will remove access to the work immediately and investigate your claim. The authors have investigated the growth of thin silver films using a unique combination of atmospheric process elements: spatial atomic layer deposition and an atmospheric pressure surface dielectric barrier discharge plasma source. Silver films were grown on top of Si substrates with good purity as revealed by resistivity values as low as 18 lX cm and C-and F-levels below detection limits of energy dispersive x-ray analysis. The growth of the silver films starts through the nucleation of islands that subsequently coalesce. The authors show that the surface island morphology is dependent on surface diffusion, which can be controlled by temperature within the deposition temperature range of 100-120 C. V C 2014 American Vacuum Society.

No abstract

The product quality of energetic materials is predominantly determined by the crystallization process applied to produce these materials. It has been demonstrated in the past that the higher the product quality of the solid energetic ingredients, the less sensitive a plastic bonded explosive containing these energetic materials becomes. The application of submicron or nanometric energetic materials is generally considered to further decrease the sensitiveness of explosives. In order to assess the product quality of energetic materials, a range of analytical techniques is available. Recent attempts within the Reduced‐sensitivity RDX Round Robin (R4) have provided the EM community a better insight into these analytical techniques and in some cases a correlation between product quality and shock initiation of plastic bonded explosives containing (RS‐)RDX was identified, which would provide a possibility to discriminate between conventional and reduced sensitivity grades.