This paper reports results on the progress in steady-state high-βp ELMy H-mode discharges in JT-60U. A fusion triple product, nD(0)τETi(0), of 3.1 × 1020 m−3 s keV under full non-inductive current drive has been achieved at Ip = 1.8 MA, which extends the record value of the fusion triple product under full non-inductive current drive by 50%. A high-beta plasma with βN ∼ 2.7 has been sustained for 7.4 s (∼60τE), with the duration determined only by the facility limits, such as the capability of the poloidal field coils and the upper limit on the duration of injection of neutral beams. Destabilization of neoclassical tearing modes (NTMs) has been avoided with good reproducibility by tailoring the current and pressure profiles. On the other hand, a real-time NTM stabilization system has been developed where detection of the centre of the magnetic island and optimization of the injection angle of the electron cyclotron wave are done in real time. By applying this system, a 3/2 NTM has been completely stabilized in a high-beta region (βp ∼ 1.2, βN ∼ 1.5), and the beta value and confinement enhancement factor have been improved by the stabilization.

In the Large Helical Device (LHD), the highest operational averaged beta value has been expanded from 3.2% to 4% in the last 2 years by increasing the heating capability and exploring a new magnetic configuration with a high aspect ratio. Although the magneto-hydrodynamic (MHD) stability properties are considered to be unfavourable in the new high aspect configuration, the heating efficiency due to neutral beams and the transport properties are expected to be favourable in a high-beta range. In order to clarify the effect of the global ideal MHD unstable mode on the operational regimes in helical systems, especially the beta gradients in the peripheral region and the beta value, the MHD analysis and the transport analysis are performed in a high-beta range of up to 4% in LHD. In a high-beta range of more than 3%, the maxima of the observed thermal pressure gradients at a low order rational magnetic surface in the peripheral region are marginally unstable to the low-mode-number ideal MHD instability. Though a gradual degradation of the local transport in the region has been observed as beta increases, a disruptive degradation of the local transport does not appear in the beta range up to 4%.

Abstract. In the Large Helical Device (LHD), the volume averaged beta value <β dia > of 5 %, which is the highest value in all of heliotron/stellarators and relevant to the reactor requirement, was achieved by optimizing the magnetic configuration from the viewpoint of magneto-hydrodynamic (MHD) characteristics, transport and heating efficiency of the neutral beam. This beta value was instantaneously obtained by pellet injection and maintained for more than 10τ E , whereas the steady state plasma with a maximum <β dia > of 4.8 % was sustained for 85τ E by the gas-puff fueling. While it is predicted theoretically that stochastization of the peripheral magnetic field structure develops with an increment of <β dia >, no serious degradation of the global confinement has been observed in the present <β dia > range. The several low-order MHD activities located in the periphery were enhanced with the beta value and sometimes affect the local profiles. The amplitude of the mode in the periphery strongly depends on the magnetic Reynolds number, which is close to that of the growth rate and/or the radial mode width of the resistive interchange instability.

Characteristics of the high-power reconnection heating were measured for the first time directly by two-dimensional measurements of ion and electron temperatures. While electrons are heated mainly inside the current sheet by the Ohmic heating power, ions are heated mainly by fast shock or viscosity damping of the reconnection outflow in the two downstream areas. The magnetic reconnection converts the energy of reconnecting magnetic field B(p) mostly to the ion thermal energy, indicating that the reconnection heating energy is proportional to B(p)(2).