Deep low permeability extra heavy oil reservoir has the characteristics of high formation pressure, high crude oil viscosity, and low permeability. Conventional steam injection thermal recovery has poor viscosity reduction performance and low productivity of a single well, which makes it difficult to develop this type of heavy oil reservoir. In this paper, core flooding experiment and microvisualization equipment were used to study the mechanism of improving the recovery of deep extra heavy oil by using water-soluble viscosity reducer; the realization of water-soluble viscosity reducer in numerical simulation was achieved by using nonlinear mixing rule; the reservoir numerical simulation model of water-soluble viscosity reducer displacement in test well group was established to optimize the development technical parameter of water-soluble viscosity reducer. The results show that compared with waterflooding, the oil displacement efficiency of water-soluble viscosity reducer is increased by 12.7%; water-soluble viscosity reducer can effectively reduce the viscosity of extra heavy oil, under the same temperature and permeability, the higher the concentration of viscosity reducer, the better the viscosity reduction effect, and the smaller the pressure gradient required at the same injection rate; the main mechanism of water-soluble viscosity reducer for enhancing oil recovery is to form oil in water emulsion, which can reduce the viscosity and interfacial tension of crude oil and reduce the residual oil saturation; in the pilot well group, the optimized injection concentration of water-soluble viscosity reducer is 3%, and the optimal injection amount of water-soluble viscosity reducer solution is 50 t/d; water-soluble viscosity reducer displacement was implemented in the pilot well group, the average daily oil of well group was increased from 1.8 t/d to 7.34 t/d, and the pilot well group has achieved good development performance.

CO2 flooding is recognized as an efficient method for enhancing shale oil recovery, while CO2-oil MMP (minimum miscibility pressure) in the micro-nanoscale is a crucial parameter. This paper presents a method for calculating the MMPs of pure hydrocarbons (C4H10, C6H14, C8H18, and C10H22) and CO2 systems in nanopores (3 nm to 10 nm) with temperature ranging from 290.15 K to 373.15 K. Firstly, we modify the Peng-Robinson equation of state (PR-EOS) by considering the influence of confinement effect and capillary pressure in nanopores. Secondly, the flash calculation algorithm is employed to determine whether the oil and gas phases in nanopores have reached an equilibrium state according to the equality of the fugacity of the two phases. Thirdly, we calculate the interfacial tension (IFT) between the two phases using the Macleod-Sugden equation. When the extrapolated IFT is zero, we treat the corresponding pressure as the MMP of the CO2-oil system in nanopores. Simulation results indicate that the calculated MMP using this method has a relative error of about 0.62% compared to the MMP calculated using the multiple mixing cell (MMC) method, indicating high reliability for MMP prediction. Moreover, the measured MMP at the nanoscale is generally smaller than that in the bulk phase due to the influence of the confinement effect. The MMP is positively correlated with the reservoir temperature, the carbon atom number in alkanes, and the nanopore radius.

No abstract

Streaming potential is one kind of electrokinetic effect coupled with fluid flow in porous media, and it has the ability to evaluate properties of rock and fluid in reservoirs. Geophysicists are much concerned about its application in geophysical survey, especially to monitor multiphase flow which is widespread in petroleum industry. To study the electrokinetic effect during multiphase flow, it is necessary to collect electrical and hydraulic parameters in real time. So we designed an acquisition system of multisensors (pressure, flow rate, electrical potential and resistivity), which could conduct measurement process automatically, introduced noise reduction algorithm to the primary analog signals. Data and control command were transmitted in network based on TCP/IP protocol and USB converter. Result from an water-oil displacement experiment showed that this system can effectively and rightly monitor the state of electrokinetic process during multiphase flo