Photocatalytic conversion of diluted CO2 into solar fuel is highly appealing yet still in its infancy. Herein, we demonstrate the metal‐node‐dependent performance for photoreduction of diluted CO2 by constructing Ni metal–organic framework (MOF) monolayers (Ni MOLs). In diluted CO2 (10 %), Ni MOLs exhibit a highest apparent quantum yield of 1.96 % with a CO selectivity of 96.8 %, which not only exceeds reported systems in diluted CO2 but also is superior to most catalysts in pure CO2. Whereas isostructural Co MOLs is almost inactive in diluted CO2, indicating the performance is dependent on the metal nodes. Experimental and theoretical investigations show that strong CO2 binding affinity of Ni MOLs is the crucial factor, which stabilizes the Ni‐CO2 adducts and facilitates CO2‐to‐CO conversion.
Hexavalent chromium contamination is a global environmental issue and usually reoccurs in alkaline reduced chromite ore processing residues (rCOPR). The oxidation of Cr(III) solids in rCOPR is one possible cause but as yet little studied. Herein, we investigated the oxidation of Cr(OH) 3 , a typical species of Cr(III) in rCOPR, at alkaline pH (9−11) with δ-MnO 2 under oxic/anoxic conditions. Results revealed three pathways for Cr(III) oxidation under oxic conditions: (1) oxidation by oxygen, (2) oxidation by δ-MnO 2 , and (3) catalytic oxidation by Mn(II). Oxidations in the latter two were efficient, and oxidation via Pathway 3 was continuous and increased dramatically with increasing pH. XANES data indicated feitknechtite (β-MnOOH) and hausmannite (Mn 3 O 4 ) were the reduction products and catalytic substances. Additionally, a kinetic model was established to describe the relative contributions of each pathway at a specific time. The simulation outcomes showed that Cr(VI) was mainly formed via Pathway 2 (>51%) over a short time frame (10 days), whereas in a longer-term (365 days), Pathway 3 predominated the oxidation (>78%) with an increasing proportion over time. These results suggest Cr(III) solids can be oxidized under alkaline oxic conditions even with a small amount of manganese oxides, providing new perspectives on Cr(VI) reoccurrence in rCOPR and emphasizing the environmental risks of Cr(III) solids in alkaline environments.
Photocatalytic conversion of diluted CO2 into solar fuel is highly appealing yet still in its infancy. Herein, we demonstrate the metal‐node‐dependent performance for photoreduction of diluted CO2 by constructing Ni metal–organic framework (MOF) monolayers (Ni MOLs). In diluted CO2 (10 %), Ni MOLs exhibit a highest apparent quantum yield of 1.96 % with a CO selectivity of 96.8 %, which not only exceeds reported systems in diluted CO2 but also is superior to most catalysts in pure CO2. Whereas isostructural Co MOLs is almost inactive in diluted CO2, indicating the performance is dependent on the metal nodes. Experimental and theoretical investigations show that strong CO2 binding affinity of Ni MOLs is the crucial factor, which stabilizes the Ni‐CO2 adducts and facilitates CO2‐to‐CO conversion.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.