We report a simple, broadband and high-absorbance coating for terahertz radiometry. The spectral properties of this coating in THz region were characterized with a home-made terahertz time-domain spectrometer. The measured spectral reflectance is less than 0.3% ranging from 0.2 THz to 0.5 THz and less than 0.1% ranging from 0.5 THz to 2.0 THz. We assembled a terahertz radiometer with this coating as absorber, and discussed its heat transfer in comparison with that of a carbon nanotube array radiometer. This coating is highly absorptive both in terahertz region and in visible light; therefore, the responsivity of this radiometer is easily traceable to National Laser Power Standards. This coating is easily fabricated. It is useful in traceability of terahertz sources and detectors to the SI units.

Light-emitting diode (LED) standard lamps are interesting since the traditional incandescent standard lamps for photometry are difficult to obtain. Many of the National Metrology Institutes have started projects to study the use of LED standards for photometric comparison. The National Institute of Metrology, China, has developed a type of LED filament lamp for total luminous flux. The lamp mimics the 4π incandescent standard lamp and has no space for an active temperature control component. A temperature dependence correction method is reported using the coefficient of the lamp voltage to the output luminous flux. The luminous flux correction is derived from the lamp voltage value. By applying correction, the stability test of the LED filament lamp shows that the ageing effect was estimated to be less than 0.1%/210 days. The temperature dependence was suppressed to less than 0.1% for a range of 21 • C ± 2 • C, which could be due to possible temperature fluctuations of the lamp ambient temperature during measurement by the goniophotometer or integrating sphere.

This paper adopted an approximation of a melting plateau to solve the problem that temperature data cannot be monitored continuously when measuring the spectral irradiance of a large area tungsten carbide–carbon high-temperature fixed-point blackbody at each measured wavelength. Tests with fully measured curves showed that the method has a rather small deviation from the measured data of 0.017 K maximum, which corresponds to the spectral irradiance deviation of 0.005% at 500 nm. The maximum relative deviation between the Akima fitting method and the measured temperature in terms of spectral irradiance was 0.002%, which was better than − 0.067 % of a single temperature of 3020.11 K method and 0.026% of a linear interpolation method.

No abstract

In this paper, we have demonstrated a magnetic field sensor based on the fiber taper coupler coated with Magnetic fluid. The proposed sensor is fabricated by immersing a fiber taper coupler into the Magnetic fluid and then sealing it with the paraffin. The sensor exhibits high response as a function of the magnetic field with sensitivities of 0.154 nm/Oe with measurement range from 50 Oe to 200 Oe and -0.06301 dB/ Oe from 75 Oe to 200 Oe. Owing to the advantages of high sensitivity, small footprint, and ease of fabrication, the proposed sensor would find potential applications in magnetic field sensing field.