Antimony-doped tin oxide (SnO2:Sb) thin films were prepared by atmospheric pressure chemical vapor deposition. Precursors were mixed with gaseous SnCl4, SbCl5, and oxygen. Both antimony and chlorine ions became involved in doping and reduced resistivity. The figure of merit suggested that films deposited at 500 °C with the ratio of SnCl4/SbCl5 equals to 0.5 have the best quality. The dopant in the degenerate films narrowed the bandgap because of interaction between electrons and impurities. A mathematical model of the shifting in bandgap is proposed with the consideration of the effective mass of the carriers and well fitted to the experimental results.

No abstract

Several kinds of azo‐dye polymer films of the guest‐host system were prepared by the spin‐coating method. Four disperse red (DR) dyes of DR1, DR19, DR54 and DR73 were chosen as second order nonlinear optical active chromophores with polymer matrixes such as poly (methyl methacrylate) PMMA or polycarbonate (PC). The processing conditions such as heat‐treatment, substrate, and film storage condition on all‐optical poling characteristics of azopolymers have been investigated. It is found that the second harmonic generation intensity is very sensitive to the chromophores and processing parameters. Some explanations have been proposed. (© 2007 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)

MnZn ferrites have been widely used as magnetic core materials. It is well known that Ca addition is effective to obtain homogeneous microstructure of fine grains and highly resistive grain boundaries. However, the behaviors of calcium as one of the main additives at different temperature ranges during sintering process are not completely understood yet. In this study, the influence of CaCO3 content and sintering temperature on the microstructure was investigated in 1473-1623 K. It was found that there existed a critical temperature around 1550 K. The grain size decreased with the increase of Ca content when the sintering temperature was lower than the critical temperature, but completely opposite result was observed at higher temperatures range. Possible mechanisms were discussed. When the sintering temperature was lower than the critical temperature, Ca content greatly affected the grain boundary mobility and dominated the grain growth. At higher temperatures, however, formation of liquid phases might be the main cause for the grain growth.

A kind of reactive type dripping agent (Tween 60-IAH) was synthesized with polyethylene glycol sorbitan monostearate (Tween 60) and itaconic anhydride (IAH) as main starting materials. The chemical structure of Tween 60-IAH was characterized by means of Fourier transform infrared (FT-IR) spectroscopy. The effect of reaction time on conversion of Tween 60-IAH was studied. The results of thermogravimetric analysis (TGA) measurement demonstrated that Tween 60-IAH exhibited a better thermal stability than Tween 60. Grafting copolymer of linear low density polyethylene (LLDPE) with Tween 60-IAH was prepared in twin-screw extruder. Thermal and rheological properties of grafted LLDPE samples were investigated with differential scanning calorimetry (DSC) and rotational rheometer. Crystallization temperatures of grafted LLDPE were higher than that of LLDPE. Complex viscosities of grafted LLDPE at high shear rates were lower than that of LLDPE. The dripping properties of film samples were investigated at 60 C.