No abstract

The in situ surface activation of unmodified CaCO(3) nanoparticles by interaction with surfactant in aqueous media has been studied, and the impact of this on the foamability and foam stability of aqueous dispersions was assessed. Using complementary experiments including measurement of particle zeta potentials, adsorption isotherms of surfactant, air-water surface tensions, and relevant contact angles, the mechanism of this activation was revealed. The results show that the non-surface-active CaCO(3) nanoparticles cannot be surface activated by interaction with cationic or nonionic surfactants but can be surface activated by interaction with anionic surfactants such as SDS and AOT, leading to a synergistic effect in both foamability and foam stability. The electrostatic interaction between the positive charges on particle surfaces and the negative charges of anionic surfactant headgroups results in monolayer adsorption of the surfactant at the particle-water interface and transforms the particles from hydrophilic to partially hydrophobic such that particles become surface active and stabilize bubbles. SDS is a more efficient surfactant for this surface activation than AOT. Possible reasons for this difference are suggested.

No abstract

Adsorption of a series of polyetheramines on montmorillonite in aqueous suspension was investigated by a range of methods: elemental analysis, atomic absorption spectroscopy, measurement of pH, conductivity and electrophoretic mobility, and small-angle X-ray scattering. Adsorption proceeds through an ion exchange mechanism. The maximum surface coverage attained is equivalent to about 40% of the cationic exchange capacity of the clay. Adsorption of the poly(oxypropylene) block adjacent to the amine group onto the clay surface may contribute to this. Surprisingly the adsorption takes place at pH conditions well above the pK(a) of the amine surfactants, where they are not protonated in the bulk solution. The surface coverage as a function of molar mass broadly agrees with predictions assuming adsorbed polymers adopt a densely packed mushroom configuration at the clay surface.

Polyelectrolyte-modified montmorillonite particles were used to stabilize oil-in-water Pickering emulsions, which were then bound together by an oil-soluble cross-linker to obtain microcapsules. It was determined how the morphology and rigidity of the microcapsules changed as polyelectrolyte and cross-linker concentrations were varied. Well-defined microcapsules could be formed by using a moderate concentration of polyelectrolyte, and the higher the cross-linker concentration, the more rigid the microcapsules. Dried microcapsules were observed using SEM, and it was shown that the clay platelets lie flat next to each other on the microcapsule surface, forming an armor-like structure.