This paper proposes a method to solve the problem of localization and mapping of a two-wheeled inverted pendulum (TWIP) robot on approximately flat ground using a Lidar–IMU–Odometer system. When TWIP is in motion, it is constrained by the ground and suffers from motion disturbances caused by rough terrain or motion shaking. Combining the motion characteristics of TWIP, this paper proposes a framework for localization consisting of a Lidar-IMU-Odometer system. This system formulates a factor graph with five types of factors, thereby coupling relative and absolute measurements from different sensors (including ground constraints) into the system. Moreover, we analyze the constraint dimension of each factor according to the motion characteristics of TWIP and propose a new nonholonomic constraint factor for the odometry pre-integration constraint and ground constraint factor in order to add them naturally to the factor graph with the robot state node on SE(3). Meanwhile, we calculate the uncertainty of each constraint. Utilizing such a nonholonomic constraint factor, a complete lidar–IMU–odometry-based motion estimation system for TWIP is developed via smoothing and mapping. Indoor and outdoor experiments show that our method has better accuracy for two-wheeled inverted pendulum robots.

No abstract

Purpose One of the development trends of robots is to enable robots to have the ability of anthropomorphic manipulation. Grasping is the first step of manipulation. For mobile manipulator robots, grasping a target during the movement process is extremely challenging, which requires the robots to make rapid motion planning for arms under uncertain dynamic disturbances. However, there are many situations require robots to grasp a target quickly while they move, such as emergency rescue. The purpose of this paper is to propose a method for target dynamic grasping during the movement of a robot. Design/methodology/approach An off-line learning from demonstrations method is applied to learn a basic reach model for arm and a motion model for fingers. An on-line dynamic adjustment method of arm speed for active and passive grasping mode is designed. Findings The experimental results of the robot movement on flat, slope and speed bumps ground show that the proposed method can effectively solve the problem of fast planning under uncertain disturbances caused by robot movement. The method performs well in the task of target dynamic grasping during the robot movement. Originality/value The main contribution of this paper is to propose a method to solve the problem of rapid motion planning of the robot arm under uncertain disturbances while the robot is grasping a target in the process of robot movement. The proposed method significantly improves the grasping efficiency of the robot in emergency situations. Experimental results show that the proposed method can effectively solve the problem.

No abstract

Purpose This paper aims to present a pipeline to progressively deal with the online external parameter calibration and estimator initialization of the Stereo-inertial measurement unit (IMU) system, which does not require any prior information and is suitable for system initialization in a variety of environments. Design/methodology/approach Before calibration and initialization, a modified stereo tracking method is adopted to obtain a motion pose, which provides prerequisites for the next three steps. Firstly, the authors align the pose obtained with the IMU measurements and linearly calculate the rough external parameters and gravity vector to provide initial values for the next optimization. Secondly, the authors fix the pose obtained by the vision and restore the external and inertial parameters of the system by optimizing the pre-integration of the IMU. Thirdly, the result of the previous step is used to perform visual-inertial joint optimization to further refine the external and inertial parameters. Findings The results of public data set experiments and actual experiments show that this method has better accuracy and robustness compared with the state of-the-art. Originality/value This method improves the accuracy of external parameters calibration and initialization and prevents the system from falling into a local minimum. Different from the traditional method of solving inertial navigation parameters separately, in this paper, all inertial navigation parameters are solved at one time, and the results of the previous step are used as the seed for the next optimization, and gradually solve the external inertial navigation parameters from coarse to fine, which avoids falling into a local minimum, reduces the number of iterations during optimization and improves the efficiency of the system.