Oomycetes and fungi are microorganisms whose pathogenic (invasive) growth can cause diseases that are responsible for significant ecological and economic losses. Such growth requires the generation of a protrusive force, the magnitude and direction of which involves a balance between turgor pressure and localised yielding of the cell wall and the cytoskeleton. To study invasive growth in individual hyphae we have developed a lab-on-a-chip platform with integrated force-sensors based on elastomeric polydimethylsiloxane (PDMS) micro-pillars. With this platform we are able to measure protrusive force (both magnitude and direction) and hyphal morphology. To show the usefulness of the platform, the oomycete Achlya bisexualis was inoculated and grown on a chip. Growth of individual hyphae into a micro-pillar revealed a maximum total force of 10 μN at the hyphal tip. The chips had no discernible effect on hyphal growth rates, but hyphae were slightly thinner in the channels on the chips compared to those on agar plates. When the hyphae contacted the pillars tip extension decreased while tip width increased. A. bisexualis hyphae were observed to reorient their growth direction if they were not able to bend and effectively grow over the pillars. Estimates of the pressure exerted on a pillar were 0.09 MPa, which given earlier measures of turgor of 0.65 MPa would indicate low compliance of the cell wall. The platform is adaptable to numerous cells and organisms that exhibit tip-growth. It provides a useful tool to begin to unravel the molecular mechanisms that underlie the generation of a protrusive force.

Molybdenum oxide (MoO3) is one of most suitable antireflection (AR) layers for silicon/poly(3,4-ethylenedioxythiophene):poly(styrenesulfonate) (Si/PEDOT:PSS) hybrid solar cells due to its well-matched refractive index (2.1). A simulation model was employed to predict the optical characteristics of Si/PEDOT:PSS hybrid solar cells with the MoO3 layers as antireflection coatings (ARCs), as well as to analyze the loss in current density. By adding an optimum thickness of a 34-nm-thick ARC of MoO3 on the front side and an effective rear back surface field (BSF) of phosphorus-diffused N+ layer at the rear side, the hybrid cells displayed higher light response in the visible and near infrared regions, boosting a short-circuit current density (Jsc) up to 28.7 mA/cm2. The average power conversion efficiency (PCE) of the Si/PEDOT:PSS hybrid solar cells was thus increased up to 11.90 %, greater than the value of 9.23 % for the reference devices.

Gambogic acid (GA) has been shown to inhibit cancer cell proliferation, induce apoptosis, and enhance reactive oxygen species accumulation. However, whether GA could improve multidrug resistance through modulating autophagy has never been explored. We demonstrated that the combination of GA and cisplatin (CDDP) resulted in a stronger growth inhibition effect on A549 and NCI-H460 cells using the MTT assay. Furthermore, treatment with GA significantly increased autophagy in these cells. More importantly, GA-induced cell death could be largely abolished by 3-methyladenine (3-MA) or chloroquine (CQ) treatment, suggesting that GA-induced cell death was dependent on autophagy. Western blot analysis showed that GA treatment suppressed the activation of Akt, mTOR, and S6. In addition, using a GA and rapamycin combination induced more cell death compared to either GA or rapamycin alone. In summary, GA may have utility as an adjunct therapy for non-small cell lung cancer (NSCLC) patients through autophagy-dependent cell death, even when cancer cells have developed resistance to apoptosis.