No abstract

Polycaprolactone (PCL) is one of the promising linear aliphatic polyesters which can be used as mulching film. Although it has suitable glass transition temperature and good biodegradability, further practical applications are restricted by the limited temperature-increasing and moisturizing properties. The rational design of the PCL structure is a good strategy to enhance the related properties. In this study, thermally-induced phase separation (TIPS) was introduced to fabricate a PCL nanoporous thin film. The introduction of a nanoporous structure on the PCL surface (np-PCL) exhibited enhanced temperature-increasing and moisturizing properties when used as mulch film. In detail, the average soil temperature of np-PCL was increased to 17.81 °C, when compared with common PCL of 17.42 °C and PBAT of 17.50 °C, and approaches to PE of 18.02 °C. In terms of water vapor transmission rate, the value for np-PCL is 637 gm−2day−1, which was much less than the common PCL of 786 and PBAT of 890 gm−2day−1. As a result, the weed biomass under the np-PCL was suppressed to be 0.35 kg m−2, almost half of the common PCL and PBAT. In addition, the np-PCL shows good thermal stability with an onset decomposition temperature of 295 °C. The degradation mechanism and rate of the np-PCL in different pH environments were also studied to explore the influence of nanoporous structure. This work highlights the importance of the nanoporous structure in PCL to enhance the temperature-increasing and moisturizing properties of PCL-based biodegradable mulching film.

Peripheral nerve injury (PNI) is a neurological disorder that causes more than 9 million patients to suffer from dysfunction of moving and sensing. Using biodegradable polymers to fabricate an artificial nerve conduit that replicates the environment of the extracellular matrix and guides neuron regeneration through the damaged sites has been researched for decades and has led to promising but primarily pre-clinical outcomes. However, few peripheral nerve conduits (PNCs) have been constructed from controllable biodegradable polymeric materials that can maintain their structural integrity or completely degrade during and after nerve regeneration respectively. In this work, a novel PNC candidate material was developed via the electrospinning of polyhydroxy butyrate/chitosan (PHB/CS) composite polymers. An SEM characterisation revealed the resultant PHB/CS nanofibres with 0, 1 and 2 wt/v% CS had less and smaller beads than the nanofibres at 3 wt/v% CS. The water contact angle (WCA) measurement demonstrated that the wettability of PHB/CS electrospun fibres was significantly improved by additional CS. Furthermore, both the thermogravimetric analysis (TGA) and differentiation scanning calorimetry (DSC) results showed that PHB/CS polymers can be blended in a single phase with a trifluoracetic solvent in all compositions. Besides, the reduction in the degradation temperature (from 286.9 to 229.9 °C) and crystallinity (from 81.0% to 52.1%) with increasing contents of CS were further proven. Moreover, we found that the degradability of the PHB/CS nanofibres subjected to different pH values rated in the order of acidic > alkaline > phosphate buffer solution (PBS). Based on these findings, it can be concluded that PHB/CS electrospun fibres with variable blending ratios may be used for designing PNCs with controlled biodegradability.