No abstract

No abstract

No abstract

The evaluation of centralised wastewater treatment plants (WWTPs) in planning and management is sometimes based solely on effluent pollutant concentrations or pollutant loads. For sanitation purposes, the effluent pollutant concentrations/loads of WWTPs are important; of course, but from the point of view of wastewater treatment, the pollutant removal performance should also be evaluated. Focussing on low- and middle-income countries, especially those in tropical regions, published kinetics studies on biological WWTPs (such as oxidation ditches and aerated lagoons) are summarised in this paper. In most studies, effluent pollutant concentrations/loads are described as first-order linear functions of influent pollutant concentrations/loads. Therefore, pollutant removal efficiencies can be expressed as first-order linear functions of the reciprocal of influent pollutant concentrations/loads with negative coefficients. This implies that pollutant removal efficiencies increase with influent pollutant concentration/load increases. Based on pollutant removal efficiency functions, biological or ecological WWTPs when operating with small influent pollutant concentrations/loads should change their management to increase influent pollutant concentrations/loads in order to increase pollutant removal efficiencies. It may, however, be possible for technological development in wastewater treatment to overcome this problem.

The concept of pollution load indicators for planning and management of the mixture conditions of centralised and on-site wastewater treatment systems has not been discussed in detail so far. In this paper, pollutant discharge (load) indicators and pollutant removal efficiencies were quantitatively analysed to develop a part of a strategy for planning and management of municipal wastewater treatment systems (WWTSs) under the mixture conditions in Bangkok, Thailand, as a case study. Pollutant discharge indicators of on-site WWTSs were estimated based on the relevant literature. Three kinds of pollutant removal efficiency function at centralised wastewater treatment plants (CWWTPs) were empirically developed for biological oxygen demand, chemical oxygen demand, total nitrogen, total phosphorus, total coliforms and faecal coliforms based on the existing CWWTP management data. These results will be integrated into the scenario-based analysis in the second paper in the series. The results will be base datasets, and the concept and estimation methods can be applied for wastewater treatment planning and management in other areas.