No abstract

Induced pluripotent stem cell (iPSC) technology enables us to investigate various potential iPSC-based therapies. Although the safety of iPSC derivation has not been completely validated, anucleate cells, such as platelets or erythrocytes, derived from iPSCs are promising targets. However, the efficiency of in vitro platelet generation from megakaryocytes (MKs) under static culture conditions is lower than is seen in vivo. In this study, we demonstrate the proof of concept by a two-dimensional flow culture system that enabled us to increase platelet yield from human embryonic stem cell or iPSC-derived MKs using a biomimetic artificial blood vessel system. The bioreactor was composed of biodegradable scaffolds with ordered arrays of pores made to mimic in vivo bone marrow through salt leaching. Within the system, two flows in different directions in which the angle between the directions of flow is 60 degrees but not 90 degrees contributed to suitable pressure and shear stress applied to MKs to promote platelet generation. Generated platelets derived from human embryonic stem cells or human induced pluripotent stem cells through the bioreactor with a 60-degree angle revealed intact integrin αIIbβ3 activation after agonist stimulation. Collectively, our findings indicate that two flows in different directions of two-dimensional flow culture may be a feasible system for in vitro generation of platelets from pluripotent stem cells (i.e., iPSC-derived MKs) in numbers sufficient for transfusion therapy.

When a sinusoidal drive current I0 cos ωt flows in a small coil close to the surface of a superconducting film, third-harmonic voltage V3 cos(3ωt+θ3) is induced in the coil if the film causes a nonlinear response. We have developed an approximate theoretical method yielding the relationships among I0, V3, and θ3, thus providing the scientific basis for a widely used inductive method for measuring the critical current density Jc in large-area superconducting films. Our results show that V3 is near zero when I0 is smaller than a threshold value Ic0∝Jcd, where d is the film thickness. When I0>Ic0, on the other hand, the third-harmonic voltage is expressed as V3 exp(−iθ3)=ωIc0G(I0/Ic0), where G(x) is a scaling function determined by the configuration of the coil. We demonstrate the scaling law of V3/Ic0 vs I0/Ic0 in a YBa2Cu3O7−δ film.

We have realized BaSi2 films by a simple vacuum evaporation technique for solar cell applications. X-ray diffraction analysis shows that single-phase BaSi2 films are formed on alkali-free glass substrates at 500 and 600 °C while impurity phases coexist on quartz or soda-lime glass substrates or at a substrate temperature of 400 °C. The mechanism of film growth is discussed by analyzing the residue on the evaporation boat. An issue on the fabricated films is cracking due to thermal mismatch, as observed by secondary electron microscopy. Optical characterizations by transmittance and reflectance spectroscopy show that the evaporated films have high absorption coefficients, reaching 2 × 104 cm−1 for a photon energy of 1.5 eV, and have indirect absorption edges of 1.14–1.21 eV, which are suitable for solar cells. The microwave-detected photoconductivity decay measurement reveals that the carrier lifetime is approximately 0.027 µs, corresponding to the diffusion length of 0.84 µm, which suggests the potential effective usage of photoexcited carriers.

No abstract