No abstract

Late fuel during closing of the valve of a fuel injector and fuel films stuck on the wall around the nozzle outlets are sources of particulate matters (PM). In this study, we focused on the effects of the valve motions on the late fuel and the fuel films stuck on the walls around the nozzle outlets. We previously developed a particle/grid hybrid method: fuel flows within the flow paths of fuel injectors were simulated by a front capturing method, and liquid-column breakup at the nozzle outlets was mainly simulated by a particle method. The velocity at the inlet boundary of a fuel injector was controlled in order to affect the valve motions on the late-fuel behavior. The simulated late fuel broke up with surface tension around the time of zero-stroke position of the valve, then liquid columns and coarse droplets formed after the bounds of the valve, and finally only coarse droplets were left. We found that the late fuel was generated by low-speed fuel-flows through the nozzles during the bounds of the valve. The effect of the bounds of the valve on the fuel films stuck on the wall around the nozzle outlets was also studied with a simulation that removed the bounds of the valve. The volume of the fuel films stuck on the wall of the nozzle outlets decreased without the bounds of the valve.

No abstract

We developed a new injector for direct injection gasoline engines that reduce the exhaust emissions and help to reduce fuel consumption. The newly developed actuator in this injector has two features. One is a bounce-less valve closing mechanism, and the second is quick-response moving parts. The first feature, the bounce-less valve closing mechanism, can prevent ejecting a coarse droplet, which causes unburned gas emission. The new actuation mechanism realizes the bounce-less valve closing. We analyzed the valve motion and injection behavior. The second feature, the quick response actuator, achieves a smaller minimum injection quantity. This feature assists in reducing the fuel consumption under low load engine conditions. The closing delay time of the needle valve is the dominant factor of the minimum injection quantity because the injection quantity is controlled by the duration time of the valve opening. The new actuator movements can be operated with a shorter closing delay time. The closing delay time is caused by a magnetic delay and kinematic delay. A compact magnetic circuit of the actuator reduces the closing delay time by 26%. In addition, the kinematic delay was improved when the hydraulic resistance was reduced by 9%. As a result, the new injector realizes reduction of the minimum injection quantity by 25% compared to a conventional injector.

No abstract