The global distribution of linear and cyclic volatile methyl silxoanes (VMS) was investigated at 20 sites worldwide, including 5 locations in the Arctic, using sorbent-impregnated polyurethane foam (SIP) disk passive air samplers. Cyclic VMS are currently being considered for regulation because they are high production volume chemicals that are potentially persistent, bioaccumulative, and toxic. Linear and cyclic VMS (including L3, L4, L5, D3, D4, D5, and D6) were analyzed for in air at all urban, background, and Arctic sites. Concentrations of D3 and D4 are significantly correlated, as are D5 and D6, which suggests different sources for these two pairs of compounds. Elevated concentrations of D3 and D4 on the West coast of North America and at high elevation sites suggest these sites are influenced by trans-Pacific transport, while D5 and D6 have elevated concentrations in urban areas, which is most likely due to personal care product use. Measured concentrations of D5 were compared to modeled concentrations generated using both the Danish Eulerian Hemispheric Model (DEHM) and the Berkeley-Trent Global Contaminant Fate Model (BETR Global). The correlation coefficients (r) between the measured and modeled results were 0.73 and 0.58 for the DEHM and BETR models, respectively. Agreement between measurements and models indicate that the sources, transport pathways, and sinks of D5 in the global atmosphere are fairly well understood.

Recently, considerable progress is achieved in lab prototype perovskite solar cells (PSCs); however, the stability of outdoor applications of PSCs remains a challenge due to the high sensitivity of perovskite material under moist and ultraviolet (UV) light conditions. In this work, the UV photostability of PSC devices is improved by incorporating a photon downshifting layer—SrAl2O4: Eu2+, Dy3+ (SAED)—prepared using the pulsed laser deposition approach. Light‐induced deep trap states in the photoactive layer are depressed, and UV light‐induced device degradation is inhibited after the SAED modification. Optimized power conversion efficiency (PCE) of 17.8% is obtained through the enhanced light harvesting and reduced carrier recombination provided by SAED. More importantly, a solar energy storage effect due to the long‐persistent luminescence of SAED is obtained after light illumination is turned off. The introduction of downconverting material with long‐persistent luminescence in PSCs not only represents a new strategy to improve PCE and light stability by photoconversion from UV to visible light but also provides a new paradigm for solar energy storage.

No abstract

No abstract