The study confirms that appropriate canal preparation techniques in simulated curved canals have little influence on stress distribution around the curvature or the orifice. However, vertical compaction induced high stress in the region just below the loading site.

In the present work, the effects of Sn, Ca additions on thermal conductivity were investigated in as cast Mg–Sn–Ca alloys. The measured values of thermal conductivity of Mg–3Sn– xCa alloys obviously increased from 85.6 to 126.3 W m− 1 K− 1 with the increasing Ca from 0 to 1.5 wt-, and then decreased to 98.3 W m− 1 K− 1 with the 2.5 wt- Ca. In addition, the thermal conductivity of the Mg–Sn–Ca (Sn/Ca atomic ratio of 1) alloys decreased slightly from 154.2 to 132.1 W m− 1 K− 1 with the increasing Sn, Ca. Meanwhile, the microstructures of the selected alloys were discussed in detail, suggesting that the solute atoms that caused lattice distortion had greater effect on thermal conductivity compared with the second phases formed in as cast Mg–Sn–Ca alloys.

Tooth morphogenesis involves dynamic changes in shape and size as it proceeds through the bud, cap, and bell stages. This process requires exact regulation of cell proliferation and differentiation. Smad7, a general antagonist against transforming growth factor–β (TGF-β) signaling, is necessary for maintaining homeostasis and proper functionality in many organs. While TGF-β signaling is widely involved in tooth morphogenesis, the precise role of Smad7 in tooth development remains unknown. In this study, we showed that Smad7 is expressed in the developing mouse molars with a high level in the dental epithelium but a moderate to weak level in the dental mesenchyme. Smad7 deficiency led to a profound decrease in tooth size primarily due to a severely compromised cell proliferation capability in the dental epithelium. Consistent with the tooth shrinkage phenotype, RNA sequencing (RNA-seq) analysis revealed that Smad7 ablation downregulated genes referred to epithelial cell proliferation and cell cycle G1/S phase transition, whereas the upregulated genes were involved in responding to TGF-β signaling and cell cycle arrest. Among these genes, the expression of Cdkn1a (encoding p21), a negative cell proliferation regulator, was remarkably elevated in parallel with the diminution of Ccnd1 encoding the crucial cell cycle regulator cyclin D1 in the dental epithelium. Meanwhile, the expression level of p-Smad2/3 was ectopically elevated in the developing tooth germ of Smad7 null mice, indicating the hyperactivation of the canonical TGF-β signaling. These effects were reversed by addition of TGF-β signaling inhibitor in cell cultures of Smad7−/− molar tooth germs, with rescued expression of cyclin D1 and cell proliferation rate. In sum, our studies demonstrate that Smad7 functions primarily as a positive regulator of cell proliferation via inhibition of the canonical TGF-β signaling during dental epithelium development and highlight a crucial role for Smad7 in regulating tooth size.

No abstract

We prepared a temperature-responsive polyurethane (PU) film with reversible visible light transmittance change, which was opaque at room temperature and became transparent when the temperature rised. The PU film has very low visible light transmittance of 1.4% at room temperature. At 45 C, the PU film has relatively high transmittance of 66.7% looking translucent. When the temperature goes to 50 C or above, the transmittance is more than 80% and the PU film is transparent. The reason for this interesting phenomenon about visible light transmittance change was illustrated by polarizing optical microscope and differential scanning calorimetry. While ultraviolet light transmittance of the PU film is very low at all time. Moreover, this PU film has excellent mechanical performance in a wide temperature range. We suppose this PU film has potential applications in many fields such as tunable optical devices or coating materials with smart temperature responsivity.