Grafting of poly(ethylene glycol) (PEG) is a common strategy for reducing nonspecific interactions of surfaces with proteins. We have used grafting at "cloud point" solution conditions that ensures maximum grafting density of linear methoxy terminated PEG-aldehyde (mPEG-ald, M(w) = 5000 and 30000). In an alternative approach, surfaces were modified with layers prepared from isocyanate terminated, star shaped poly(ethylene glycol-stat-propylene glycol) prepolymers (80% ethylene glycol, six arms, M(w) = 3000, 12,000, and 18,000; this compound will be referred to as "Star PEG" in the text). Due to the highly reactive endgroups, these molecules form a dense network on the substrate with a high polymer surface coverage. The two systems were compared regarding their ability to prevent unspecific adsorption of insulin and lysozyme. The layers were analyzed by ellipsometry, contact angle measurements, and XPS. Protein adsorption was monitored by surface MALDI-TOF MS and fluorescence microscopy. No protein adsorption could be detected on Star PEG coatings and on mPEG-ald 5000, whereas mPEG-ald 30,000 could only prevent adsorption of lysozyme but not of the smaller insulin.

No abstract

Interaction forces between surfaces designed to be protein resistant and fibrinogen (Fg) were investigated in phosphate-buffered saline with colloid probe atomic force microscopy. The surfaces of the silica probes were coated with a layer of fibrinogen molecules by adsorption from the buffer. The technique of low-power, pulsed AC plasma polymerization was used to make poly(ethylene glycol) (PEG)-like coatings on poly(ethylene teraphthalate) by using diethylene glycol vinyl ether as the monomer gas. The degree of PEG-like nature of the films was controlled by use of a different effective plasma power in the chamber for each coating, ranging from 0.6 to 3.6 W. This produced a series of thin films with a different number of ether carbons, as assessed by X-ray photoelectron spectroscopy. The interaction force measurements are discussed in relation to trends observed in the reduction of fibrinogen adsorption, as determined quantitatively by (125)I radio-labeling. The plasma polymer coatings with the greatest protein-repelling properties were the most PEG-like in nature and showed the strongest repulsion in interaction force measurements with the fibrinogen-coated probe. Once forced into contact, all the surfaces showed increased adhesion with the protein layer on the probe, and the strength and extension length of adhesion was dependent on both the applied load and the plasma polymer surface chemistry. When the medium was changed from buffer to water, the adhesion after contact was eliminated and only appeared at much higher loads. This indicates that the structure of the fibrinogen molecules on the probe is changed from an extended conformation in buffer to a flat conformation in water, with the former state allowing for stronger interaction with the polymer chains on the surface. These experiments underline the utility of aqueous surface force measurements toward understanding protein-surface interactions, and developing nonfouling surfaces that confer a steric barrier against protein adsorption.

We utilise pulsed AC plasma polymerisation to create thin films that either contain reactive acid functional groups (by deposition of maleic anhydride (MAH) followed by hydrolysis) or are poly(ethylene glycol) (PEG)-like in nature (by using diethylene glycol vinyl ether (DEGVE) as monomer). The MAH films were further modified with PEG chains using a two-step wet chemical method. For the DEGVE films the plasma power was varied in order to change the degree of monomer fragmentation and thus retention of PEG-like character. The chemistry of the surfaces was determined using Fourier-transform infrared spectroscopy (FTIR), X-ray photoelectron spectroscopy (XPS), and time-of-flight secondary ion mass spectroscopy (ToF SIMS). Significant reduction (up to 90%) in protein adsorption was achieved by the plasma polymer surfaces as determined using 125 I-radiolabelled fibrinogen adsorption experiments.AC plasma experimental setup.

No abstract