No abstract

Hemolysis and thrombus formation which are critical concerns in designing a long-term implantable ventricular assist device (VAD) have impeded the widespread use of VADs. In this study, thus, the three-dimensional fluid domain of blood flow in a small bichamber positive displacement VAD (25 ml) with a magnetically levitated moving pusher plate was simulated by the means of a finite element package called ADINA. To optimize the function of the pump for minimizing shear stress induced blood damage, three different driver patterns (linear, sinusoidal, and Guyton's pulse) were investigated. The first pattern produced a constant flow, whereas the two others created pulsatile flows. The flow pattern and the distribution of shear stress of each pattern were observed for comparison. It was revealed that the three types of motions may induce less than 0.06% red blood cell damage. Moreover, in comparison to the other patterns not only did the sinusoidal motion of the pusher plate cause less risk of hemolysis, but in comparison to the linear pattern, it produced a pulsatile flow which reduced the stagnation areas in chambers, lowering the probability of thrombosis. In addition, this motion eliminates the probability of cavitations as compared with the Guyton's pulse pattern.

The need for cell and particle sorting in human health care and biotechnology applications is undeniable. Inertial microfluidics has proven to be an effective cell and particle sorting technology in many of these applications. Still, only a limited understanding of the underlying physics of particle migration is currently available due to the complex inertial and impact forces arising from particle–particle and particle–wall interactions. Thus, even though it would likely enable significant advances in the field, very few studies have tried to simulate particle-laden flows in inertial microfluidic devices. To address this, this study proposes new codes (solved in OpenFOAM software) that capture all the salient inertial forces, including the four-way coupling between the conveying fluid and the suspended particles traveling a spiral microchannel. Additionally, these simulations are relatively (computationally) inexpensive since the arbitrary Lagrangian–Eulerian formulation allows the fluid elements to be much larger than the particles. In this study, simulations were conducted for two different spiral microchannel cross sections (e.g., rectangular and trapezoidal) for comparison against previously published experimental results. The results indicate good agreement with experiments in terms of (monodisperse) particle focusing positions, and the codes can readily be extended to simulate two different particle types. This new numerical approach is significant because it opens the door to rapid geometric and flow rate optimization in order to improve the efficiency and purity of cell and particle sorting in biotechnology applications.