The central aim of this paper is to use OpenFOAM for the assessment of mesh resolution requirements for large-eddy simulation (LES) of flows similar to the ones which occur inside the draft-tube of hydraulic turbines at off-design operating conditions. The importance of this study is related to the fact that hydraulic turbines often need to be operated over an extended range of operating conditions, which makes the investigation of fluctuating stresses crucial. Scale-resolving simulation (SRS) approaches, such as LES and detached-eddy simulation (DES), have received more interests in the recent decade for understanding and mitigating unsteady operational behavior of hydro turbines. This interest is due to their ability to resolve a larger part of turbulent flows. However, verification studies in LES are very challenging, since errors in numerical discretization, but also subgrid-scale (SGS) models, are both influenced by grid resolution. A comprehensive examination of the literature shows that SRS for different operating conditions of hydraulic turbines is still quite limited and that there is no consensus on mesh resolution requirement for SRS studies. Therefore, the goal of this research is to develop a reliable framework for the validation and verification of SRS, especially LES, so that it can be applied for the investigation of flow phenomena inside hydraulic turbine draft-tube and runner at their off-design operating conditions. Two academic test cases are considered in this research, a turbulent channel flow and a case of sudden expansion. The sudden expansion test case resembles the flow inside the draft-tube of hydraulic turbines at part load. In this study, we concentrate on these academic test cases, but it is expected that hydraulic turbine flow simulations will eventually benefit from the results of the current research. The results show that two-point autocorrelation is more sensitive to mesh resolution than energy spectra. In addition, for the case of sudden expansion, the mesh resolution has a tremendous effect on the results, and, so far, we have not capture an asymptotic converging behavior in the results of Root Mean Square (RMS) of velocity fluctuations and two-point autocorrelation. This case, which represents complex flow behavior, needs further mesh resolution studies.

No abstract

In this paper, the application of the surface mass transfer optimization in shock wave-boundary layer interaction control at off-design conditions of transonic aircraft wing is presented. The suction or injection parameters include for example its position on the airfoil, its angle, the length of the hole and the rate of the injected or sucked flow. The optimization process is carried out using an efficient Genetic Algorithm (GA) method. The compressible viscous flow equations in Reynolds Averaged form are solved together with a twoequation k-epsilon turbulence model to accurately compute the objective function. Four different objective functions are introduced including maximum lift to drag ratio, minimum drag coefficient, maximum lift to drag ratio with no drag increment and minimum drag coefficient with no lift decrement. Effectiveness of each objective function is examined by comparing the optimum results in terms of the flow control parameters and flow characteristics.