Conjugated polymeric molecules have been heralded as promising electrode materials for the next-generation energy-storage technologies owing to their chemical flexibility at the molecular level, environmental benefit, and cost advantage. However, before any practical implementation takes place, the low capacity, poor structural stability, and sluggish ion/electron diffusion kinetics remain the obstacles that have to be overcome. Here, we report the synthesis of a few-layered two-dimensional covalent organic framework trapped by carbon nanotubes as the anode of lithium-ion batteries. Remarkably, upon activation, this organic electrode delivers a large reversible capacity of 1536 mAh g −1 and can sustain 500 cycles at 100 mA g −1 . Aided by theoretical calculations and electrochemical probing of the electrochemical behavior at different stages of cycling, the storage mechanism is revealed to be governed by 14-electron redox chemistry for a covalent organic framework monomer with one lithium ion per C=N group and six lithium ions per benzene ring. This work may pave the way to the development of high-capacity electrodes for organic rechargeable batteries.

The development of a feasible and inexpensive strategy to obtain and utilize sustainable energy is an important issue for the sustainable development of human society. Over the past decade, significant progress has been made in the development of novel functional materials for energy conversion and storage. Owing to their unique physico‐chemical properties, 2D layered materials, such as graphene and transition metal dichalcogenides, have attracted great interest in energy‐related research. 1T‐MoS2 is a metallic phase of molybdenum disulfide (MoS2) with extraordinary electronic conductivity, enlarged interlayer spacing, and more electrochemically active sites along the basal plane, which offers intriguing benefits for energy‐related applications compared to its semiconducting counterpart (2H‐MoS2). This review summarizes the preparation and structure–property relationships of 1T‐MoS2, as well as the underlying relations between the metallic (1T) and semiconducting (2H) phases of MoS2. Recent progress in the preparation and stabilization of 1T‐MoS2 materials and their applications for energy conversion and storage are discussed, including water splitting to form hydrogen via photo/electrocatalysis and electricity storage in lithium‐ion batteries, sodium‐ion batteries, magnesium‐ion batteries, and supercapacitors. Optimization strategies of 1T‐MoS2 to obtain enhanced practical properties based on theoretical calculations are also presented.

The Boltzmann distribution of electrons sets a fundamental barrier to lowering energy consumption in metal-oxide-semiconductor field-effect transistors (MOSFETs). Negative capacitance FET (NC-FET), as an emerging FET architecture, is promising to overcome this thermionic limit and build ultra-low-power consuming electronics. Here, we demonstrate steep-slope NC-FETs based on two-dimensional molybdenum disulfide and CuInP 2 S 6 (CIPS) van der Waals (vdW) heterostructure. The vdW NC-FET provides an average subthreshold swing (SS) less than the Boltzmann’s limit for over seven decades of drain current, with a minimum SS of 28 mV dec −1 . Negligible hysteresis is achieved in NC-FETs with the thickness of CIPS less than 20 nm. A voltage gain of 24 is measured for vdW NC-FET logic inverter. Flexible vdW NC-FET is further demonstrated with sub-60 mV dec −1 switching characteristics under the bending radius down to 3.8 mm. These results demonstrate the great potential of vdW NC-FET for ultra-low-power and flexible applications.