According to finite-time thermodynamics, an irreversible high temperature proton exchange membrane fuel cell (HT-PEMFC) model is established, and the mathematical expressions of the output power, energy efficiency, exergy efficiency and ecological coefficient of performance (ECOP) of HT-PEMFC are deduced. The ECOP is a step forward in optimizing the relationship between power and power dissipation, which is more in line with the principle of ecology. Based on the established HT-PEMFC model, the maximum power density is obtained under different parameters that include operating temperature, operating pressure, phosphoric acid doping level and relative humidity. At the same time, the energy efficiency, exergy efficiency and ECOP corresponding to the maximum power density are acquired so as to determine the optimal value of each index under the maximum power density. The results show that the higher the operating temperature and the doping level, the better the performance of HT-PEMFC is. However, the increase of operating pressure and relative humidity has little effect on HT-PEMFC performance.

According to operation characteristics of the main engine 9K98ME-C7, a combined turbines-exhaust gas waste heat recovery system is proposed to recover waste heat and increase system energy efficiency.

A finite time thermodynamic model of an irreversible proton exchange membrane fuel cell (PEMFC) for vehicle use was established considering the effects of polarization losses and leakage current. Effects of operating parameters, including operating temperature, operating pressure, proton exchange membrane water content, and proton exchange membrane thickness, on the optimal performance of the irreversible PEMFC are numerically studied in detail. When the operating temperature of the PEMFC increases, the optimal performances of PEMFC including output power density, output efficiency, ecological objective function, and ecological coefficient of performance, will be improved. Among them, the optimal ecological objective function increased by 81%. The proton film thickness has little effect on the output efficiency and the ecological of coefficient performance. The maximum output power density increased by 58% as the water content of the proton exchange membrane increased from 50% to the saturation point. The maximum output power density increases with the operating pressure.

In order to improve fuel economy and enhance operating efficiency of fuel cell hybrid vehicles (FCHVs), fuzzy logic control (FLC) strategies are available and suggested for adoption. In this paper, the powertrain of a fuel cell hybrid vehicle is designed and the parameters of the motor, battery, and fuel cell are calculated. The FLC strategy and the power following control (PFC) strategy are designed for the studied FCHV. A secondary development for Advanced Vehicle Simulator (ADVISOR) is implemented based on the standard driving cycles, and a Chinese typical city driving cycle is imported. Simulation results demonstrate that the proposed FLC strategy is more valid and reasonable than the traditional PFC strategy. The proposed FLC strategy affects the vehicle characteristics significantly and contributes to better performance in four aspects: fuel economy, efficiency of battery and fuel cell system, battery state of charge (SOC), and battery life. Hence, the FLC strategy is more suitable for the energy management strategy for fuel cell and battery hybrid vehicles.

This paper investigates the front-wheel differential steering system (DSS) for a four-wheel independent-drive (4WID) electric vehicle (EV) with a steer-by-wire (SBW) system in case of the steering failure. The nonlinear dynamic model of differential steering vehicle (DSV) is established and the stability regions at different adhesion coefficients are determined based on the theory of phase plane. The traditional front-wheel steering vehicle is selected as the reference model. The direct yaw moment control (DYC) aiming to restore the vehicle to the stability region, and the DSS control aiming to achieve the normal steering function based on the theory of model reference sliding mode control, are researched and applied to the nonlinear dynamic model successively. The direct yaw moment and differential driving torque of the frontwheel needed for the vehicle stability and DSS are obtained respectively. The simulation results show that the proposed integrated control can simultaneously ensure the differential steering and vehicle stability of the nonlinear vehicle on different adhesion coefficient roads. INDEX TERMS Differential steering system, four-wheel independent-drive, differential steering vehicle, direct yaw moment, integrated control.