The synthesis and single-crystal X-ray structures of two quinacridone derivatives, N,N'-di(n-butyl)quinacridone (1) and N,N'-di(n-butyl)-1,3,8,10-tetramethylquinacridone (2), are reported, and the 1H NMR, absorption, photoluminescent (PL), and electroluminescent (EL) characteristics are presented. Both these crystal structures are characterized by intermolecular pi...pi and hydrogen bonding interactions. The intermolecular pi...pi interactions lead to the formation of molecular columns in the solids of 1 and 2, and the interplanar contact distances between two adjacent molecules are 3.48 and 3.55 angstroms, respectively. Crystals of 1 display shorter intermolecular pi...pi contacts and higher density than 2. These results suggest that tighter intermolecular interactions exist in 1. The 1H NMR, absorption, and PL spectra of 1 and 2 in solutions exhibit concentration-dependent properties. The PL quantum yields of 1 in solutions decrease more quickly with the increase of concentration compared to that of 2 in solutions. For solid thin films of Alq3:1 (Alq3 = tris(8-hydroxyquinolinato)aluminum), emission intensities dramatically decrease and obvious red shifts are observed when the dopant concentration is above 4.2%, while for films of Alq3:2, a similar phenomenon occurs when the concentration is above 6.7%. EL devices with Alq3:1 as emitting layer only show high efficiencies (20.3-14.5 cd/A) within the narrow dopant concentration range of 0.5-1.0%. In contrast, high efficiencies (21.5-12.0 cd/A) are achieved for a wider dopant concentration range of 0.5-5.0% when Alq3:2 films are employed as emitting layer. The different PL and EL concentration-dependent properties of the solid thin films Alq3:1 and Alq3:2 are attributed to their different molecular packing characteristics in the solid state.

No abstract

No abstract

Recently, trivalent chromium ion doped phosphors have exhibited significant application potential in broadband near-infrared (NIR) phosphor-converted light-emitting diodes (pc-LEDs). However, developing an NIR phosphor with both broad emission bandwidth and excellent luminescence thermal stability is still a great challenge. Here, we demonstrate an NIR phosphor, ScF3:Cr3+, which can fulfill both conditions simultaneously. The prepared phosphors show broadband emission in the range of 700 to 1100 nm, with a full width at half-maximum (FWHM) of 140 nm peaking at 853 nm. These phosphors also demonstrate an excellent luminescence thermal stability (the emission intensity of ScF3:Cr3+ keeps 85.5% at 150 °C compared with the value at room temperature). An NIR pc-LED based on blue LED chips was fabricated and tested. The results show that the NIR pc-LED can yield strong broadband NIR emission. This work not only provides a promising phosphor for the application of NIR pc-LEDs but also has important guiding significance for effect of synthesis conditions on the luminescence properties of Cr3+-doped fluorides.