In the case of a single scene feature, the positioning of an indoor service robot takes a long time, and localization errors are likely to occur. A new method for a hybrid indoor localization system according to multi-sensor fusion is proposed to solve these problems. The localization process is divided in two stages: rough positioning and precise positioning. By virtue of the K nearest neighbors based on possibility (KNNBP) algorithm first created in the present study, the rough position of a robot is determined according to the received signal strength indicator (RSSI) of Wi-Fi. Then, the hybrid particle filter localization (HPFL) algorithm improved on the basis of adaptive Monte Carlo localization (AMCL) is adopted to get the precise localization, which integrates various information, including the rough position and information from Lidar, a compass, an occupancy grid map, and encoders. The experiments indicated that the positioning error was 0.05 m; the success rate of localization was 96% with even 3000 particles, and the global positioning time was 1.9 s. However, under the same conditions, the success rate of AMCL was approximately 40%, the required time was approximately 25.6 s, and the positioning accuracy was the same. This indicates that the hybrid indoor location system is efficient and accurate.

No abstract

SummaryPath planning under 2D map is a key issue in robot applications. However, most related algorithms rely on point-by-point traversal. This causes them usually cannot find the strict shortest path, and their time cost increases dramatically as the map scale increases. So we proposed RimJump to solve the above problem, and it is a new path planning method that generates the strict shortest path for a 2D map. RimJump selects points on the edge of barriers to form the strict shortest path. Simulation and experimentation prove that RimJump meets the expected requirements.

A globally consistent map is the basis of indoor robot localization and navigation. However, map built by Rao-Blackwellized Particle Filter (RBPF) doesn't have high global consistency which is not suitable for long-term application in large scene. To address the problem, we present an improved RBPF Lidar SLAM system with loop detection and correction named LCPF. The efficiency and accuracy of loop detection depend on the segmentation of submaps. Instead of dividing the submap at fixed number of laser scan like existing method, Dynamic Submap Segmentation is proposed in LCPF. This segmentation algorithm decreases the error inside the submap by splitting the submap where there is high scan match error and later rectifies the error by an improved pose graph optimization between submaps. In order to segment the submap at appropriate point, when to create a new submap is determined by both the accumulation of scan match error and the particle distribution. Furthermore, LCPF uses branch and bound algorithm as basic detector for loop detection and multiple criteria to judge the reliability of a loop. In the criteria, a novel parameter called usable ratio was proposed to measure the useful information that a laser scan containing. Finally, comparisons to existing 2D-Lidar mapping algorithm are performed with a series of open dataset simulations and real robot experiments to demonstrate the effectiveness of LCPF.

With the rapid development of embedded technology, mobile devices have been widely used than before. Face recognition has also been taken as a key application with PCA as the basic algorithm. Though PCA can provide basic information processing, it still has some problems to be used for mobile devices. The movement of the faces increases the difficulty of the recognition and the limited resources of mobile devices propose more constraints to traditional PCA algorithm. A novel approach is presented to optimize PCA based face recognition for better performance and faster recognition speed. The experiments show that the new approach can achieve its target though the optimization.