Sharia Banking in Indonesia has a Sharia Supervisory Board that can monitor the operation of Sharia banks so that they are different from other banks. It is hoped that with this monitoring system the operation of corporate governance will be better. This study aims to explain the differences in the application of Good Corporate Governance (GCG) between Islamic banking in Indonesia. Sharia Bank is a bank whose application is different from conventional banks. Where one of the differences is the existence of a Sharia Supervisory Board which ensures bank activities are based on sharia. Then conducted a study of Islamic banks during 2014 to 2018. This research method uses descriptive analysis based on data that has been reported by each Islamic banking. The results of the survey showed that BCA Syariah and BSM received the highest rating among other sharia banks. This explanation shows that the implementation of corporate governance has been "very good" and has been in accordance with the stipulated provisions. BNIS, BRIS, Bukopin Syariah Bank, Mega Syariah Bank, Panin Syariah Bank, Victoria Syariah Bank, and Maybank Syariah, each ranked 2 (two). This means that the implementation of corporate governance goes "well". Interestingly, the Muamalat bank which has been the oldest BUS in Indonesia is ranked 3 (three). This means that the application of corporate governance is "good enough". Some notes on Muamalat's bank that must be corrected.

This paper discusses the granulator machine testing process. This test aims to determine the process of occurrence of granular. Granular pellets are one form of feed pellets, granular (rounded) and light in weight. Granular pellets are not easy to sink but are easily broken down in water. This type of pellet is made without going through the process of pressing, so that it can produce feed grains that are light weighted, not easily submerged but easily decomposed in water. The goal is to determine the optimal state of the granulator machine with three angular tilt positions, it can perform maintenance on the granulator machine. The granulator machine testing process is carried out by means of the plate angle measurement process, the water mixture measurement process, the plate speed measurement process. Material used for the testing process uses flour and water. While the tools used in the granulator machine testing process are spray, 14 key, sieve, and container. After testing at 3 angles at an angle of 25o, angle of 30o and angle of 35o the authors conclude that this machine can produce small granules at a slope of 250 with an engine speed of 17 rpm and average weight of granular which is produced 236 grams. While the results of hourly 3 kg / hour.