"Analysis of CdTe Probes"

We describe a stacked detector made of thin cadmium telluride (CdTe) diode detectors. By using a thin CdTe device, we can overcome the charge loss problem due to the small mobility and short lifetime of holes in CdTe or cadmium zinc telluride (CdZnTe) detectors. However, a CdTe detector with a thickness of more than 5 mm is needed for adequate detection efficiency for gamma-rays of several hundred keV. Good energy resolution and good peak detection efficiency are difficult to obtain using such a thick CdTe detector. The stacked detector enabled us to realize a detector with both high-energy resolution and good efficiencies for gamma rays up to several hundred keV. In order to verify this concept, we constructed a prototype made of ten layers of a 0.5-mm-thick CdTe diode detectors with a surface area of 21.5 mm 21.5 mm. With this, we have achieved 5.3-keV and 7.9-keV energy resolution [full width at half maximum (FWHM)] at 356 keV and 662 keV, respectively, at the temperature of 20 C.Index Terms-Cadmium telluride (CdTe), CdTe diode detector, cadmium zinc telluride (CdZnTe), stacked detector.

show abstract

“…Most of them are based on the concept of the single polarity charge-sensing method (e.g., [3]- [8]). …”

Section: Introductionmentioning

confidence: 99%