Concurrent wafer-level measurement of longitudinal and transverse effective piezoelectric coefficients (d33,f and e31,f) by double beam laser interferometry

Abstract

In a recently published paper [S. Sivaramakrishnan et al., Appl. Phys. Lett. 103, 132904 (2013)], the electrode-size dependence of the longitudinal effective piezoelectric coefficient (d33,f) of piezoelectric thin films measured by double beam laser interferometry was shown to be due to the substrate clamping effects. It was also shown that the true d33,f is measured when the ratio of the electrode size to the substrate thickness is approximately unity, in the case of a substrate with isotropic elastic properties and a Poisson's ratio of ∼0.3. In this paper, we further investigate the dependence of the critical ratio (rc) of the electrode size to the substrate thickness at which the true d33,f is measured on the substrate Poisson's ratio for isotopic substrates and for the important case of the anisotropic Si substrate. It turns out that it is the out-of-plane Poisson's ratio (-s13/s11) that is relevant for this measurement technique and not the in-plane Poisson's ratio which is highly anisotropic for the (001) oriented Si. Furthermore, we show that the transverse effective piezoelectric coefficient (e31,f) can also be determined from the same measurement of the electrode size dependence of d33,f. This provides a convenient non-destructive wafer-level measurement technique for the determination of both the piezoelectric coefficients simultaneously. Moreover, this technique is also capable of measuring e31,f under varying electric field excitation which is important for many applications such as actuators.

AlScN: A III-V semiconductor based ferroelectric

“…The inverse piezoelectric effect was measured with a triangular voltage input at 211 Hz. Due to systematic errors arising from non-neglectable substrate deformation during measurements of the inverse piezoelectric effect, [21] a correction factor of 0.85 was multiplied with the measured strain response (see supporting information). Polarization inversion was initiated through a unipolar 0.1 Hz sine wave with a peak value of -200 V over 60s.…”

Mechanical-Resonance-Enhanced Thin-Film Magnetoelectric Heterostructures for Magnetometers, Mechanical Antennas, Tunable RF Inductors, and Filters

“…The permittivity and dielectric loss of the films can be obtained by measurement using impedance analyzer. To measure the piezoelectric coefficient of the films, a direct measurement approach based on double-beam interferometer was often used, the main characteristic of which is to discriminate the true film expansion from the bimorph-like binding of the sample [42,47]. In addition, many indirect measurement techniques based on cantilever structures [37], surface-acoustic-wave (SAW) resonators [48], and bulk-acoustic-wave (BAW) resonators [38] were also demonstrated to be effective to extract the piezoelectric coefficients.…”

Impact of process conditions on chemical solution deposited BNKT thin film electromechanical properties

“…To prepare samples for electrical characterization, Pt top electrodes were DC sputtered through a shadow mask. The diameter of the electrode holes on the shadow mask was 0.675 mm which is approximately equivalent to overall film/substrate thickness [28,29]. It should be noted that the actual diameter of the sputtered platinum electrodes may be slightly larger/smaller than the size of the holes on the shadow mask.…”