Design and Fabrication of a Microfluidic Viscometer Based on Electrofluidic Circuits

Abstract

This paper reports a microfluidic viscometer based on electrofluidic circuits for measuring viscosities of liquid samples. The developed micro-device consists of a polydimethylsiloxane (PDMS) layer for electrofluidic circuits, a thin PDMS membrane, another PDMS layer for sample pretreatment, and a glass substrate. As the sample flows inside the microfluidic channel, its viscosity causes flow resistance and a pressure drop along this channel. This pressure drop, in turn, generates a hydraulic pressure which deforms the PDMS membrane, causing changes in the cross-sectional area and the electrical resistance of the electrofluidic resistor. This small resistance change is then measured via the electrofluidic Wheatstone bridge to relate the measured voltage difference to the fluidic viscosity. The performance of this viscometer was first tested by flowing nitrogen gas with controllable pressures into the device. The relationship between measured voltage difference and input gas pressure was analyzed to be linear in the pressure range of 0–15 psi. Another test using pure water indicated good linearity between measured voltage difference and flow rate in the rate range of 20–100 μL/min. Viscosities of glycerol/water solutions with volume/volume (v/v) concentrations ranging from 0 to 30% were measured, and these values were close to those obtained using commercially available viscometers. In addition, the sample-pretreatment layer can be used to mix and/or dilute liquid samples to desired concentrations. Therefore, this microfluidic device has potential for measurements of fluidic viscosity in a fast, accurate, and high-throughput manner.

Innovative Strain Sensing for Detection of Exterior Wall Tile Lesion: Smart Skin Sensory System

“…During the experiments in this study, changes in the resistance values of the string-type strain gauges were extremely small and difficult to determine directly. Therefore, a conversion circuit was used to convert the changes in resistance values into voltage signals; the Wheatstone bridge is the most commonly used resistance conversion circuit and one that is the most suitable circuit for measuring small resistance changes [16]. However, commercially available resistors often contain errors.…”

A method to measure non-Newtonian fluids viscosity using inertial viscometer with a computer vision system

“…The authors noted that on similar viscometers [48,49,50] for Newtonian fluids, errors of 3-10 %, 4-7 %, 5-24 %, respectively, were obtained in comparison with commercial viscometers. Tzeng et al [51] presented another microfluidic viscometer based on electrofluidic circuits. The viscosity of the tested fluid sample is estimated by its flow resistance, which is a function of pressure drop, flow rate, and the geometry of the microfluidic channel.…”

A Review of Microfluidic Devices for Rheological Characterisation

“…After performing an accurate calibration, the authors employed their microfluidic rheometer to measure the viscosity values of Newtonian glycerol solutions, as well as non-Newtonian solutions such as whole blood at different temperatures (25 • C and 37 • C), finding good agreement with conventional bulk measurements (Figure 2f). A similar system was also introduced by Tzeng and Sun [24] for the measurement of glycerol-water solutions at different volume concentrations. A portable microfluidic rheometer called Viscopette was introduced by Lee et al [19] (Figure 2g).…”