Dose calibration of Gafchromic EBT3 film for Ir-192 brachytherapy source using 3D-printed PLA and ABS plastics

Abstract

3D printing technology has allowed the creation of custom applicators for high dose rate (HDR) brachytherapy, especially for complex anatomy. With conformal therapy comes the need for advanced dosimetric verification. It is important to demonstrate how dose to 3D printed materials can be related to dose to water. This study aimed to determine dose differences and uncertainties using 3D printed PLA and ABS plastics for Radiochromic film calibration in HDR brachytherapy. Gafchromic EBT3 film pieces were irradiated in water with an Ir-192 source at calculated dose levels ranging from 0 to 800 cGy, to create the control calibration curve. Similarly, film was placed below 3D printed PLA and ABS blocks and irradiated at the same dose levels calculated for water, ranging from 0 to 800 cGy. After a 72-h development time, film pieces were scanned on a flatbed scanner and the median pixel value was recorded in the region of highest dose. This value was converted to net optical density (NOD). A rational function was used to fit a calibration curve in water that relates NOD to dose for red, green, and blue color channels. Based on this fitted curve, ABS and PLA NOD values were used to estimate dose in 3D printed plastics. From the fitted calibration curve, mean residual error between measured and planned dose to water was less than 1% for each color channel at high dose levels. At high dose levels, ABS and PLA mean residual errors were about 6.9 and 7.8% in the red channel, while 5.2 and 5.7% in the green channel. Combined uncertainties measured to be about 6.9% at high dose levels. This study demonstrated dose differences and uncertainties using 3D printed applicators for HDR Ir-192 brachytherapy.

Manufacturing and evaluation of multi-channel cylinder applicator with 3D printing technology

“…In order to select a material, biocompatibility, serializable and homogenic printing product, and water equivalency (specially for TPS with TG-43 algorithm) for brachytherapy need to be considered. Most of the studies used PA, PLA, ABS, and PC-ISO as a material with fused deposition modeling (known as FDM) technique [ 19 , 21 , 29 , 39 , 40 ]. Resin is yet another material with different sub-types, including rigid resin, tough resin, elastic resin, flexible resin, and high-temp resin for different purposes, with almost the same density.…”

Dosimetric assessment of the impact of low-cost materials used in stereolithography in high-dose-rate brachytherapy

“…This setup was built as a phantom printed with FDM technology using PLA material. Studies conducted by Orae suggest that use of PLA for calibration of EBT3 dosimetric film is justified [ 15 ]. On the other hand, we acknowledge that it may be reasonable to calibrate films using Linac setup due to high measurement uncertainty.…”

Surgical and Radiological Management of Complicated Uterine Leiomyoma Aided by 3D Models in a Patient with Fibrodysplasia Ossificans Progressiva

“…Advances in technology and affordability have expanded the use of 3D models for surgical planning, simulation training, and patient education. Previous studies have reported greater patient understanding of anatomy, disease, and surgical procedure and reduced operating room costs with the use of 3D models [ 14 , 16 ]. In a previous case, a 3D model of the thorax and tracheobronchial tree of a patient with FOP and recurrent left lower-lobe pneumonia demonstrated severe obliteration of the left bronchial tree secondary to severe kyphoscoliosis.…”