Exploring the performance of prototype filters for broadband PLC

Pinto-Benel, Freddy A.; Cruz–Roldán, Fernando

doi:10.1109/isplc.2017.7897104

Cited by 3 publications

(1 citation statement)

References 6 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Depending on the end application, broadband PLC [22] and low-frequency narrowband PLC will be discussed. Broadband PLC (also BPL-Broadband over Power Line) permits a >100 Mbps data rate and usually works on the 2-30 MHz band (also with the possibility to use 30-86 MHz as an additional bandwidth).…”

Section: Introductionmentioning

confidence: 99%

Disturbance and Signal Filter for Power Line Communication

et al. 2019

View full text Add to dashboard Cite

Today, to use home automation, intelligent home controls or remote controls in the office, electronic equipment is moving away from wireless communication in favor of Power Line Communication (PLC). In the standard PLC solutions, the corrections that result from error transmissions are based on complex digital modulation methods and algorithms for validating the transmitted data without paying attention to the causes of the errors. This article focuses on the implementation of a filtering system for interference and signals in the 120–150 kHz band (CENELEC band C), which is injected into the network by transmitters. Such a filter separates the desired signal from the interference that is occurring in the network, which can result in communication errors. Moreover, when used properly, the filter can be used as a subsystem separation element. The paper presents the requirements, design, construction, simulation and test results that were obtained under actual operating conditions. It is possible to use less complex methods for correcting errors in transmission signals and to guarantee an improvement in the transmission rate using the proposed filter system.

show abstract

Section: Introductionmentioning

confidence: 99%