Impact of vapor polishing on surface quality and mechanical properties of extruded ABS

Abstract

Purpose Additive manufacturing (AM) is readily capable of producing models and prototypes of complex geometry and is advancing in creating functional parts. However, AM processes typically underperform traditional manufacturing methods in mechanical properties, surface roughness and hermeticity. Solvent vapor treatments (vapor polishing) are commonly used to improve surface quality in thermoplastic parts, but the results are poorly characterized. Design/methodology/approach This work quantifies the surface roughness change and also evaluates the effect on hermeticity and mechanical property impacts for “as-printed” and acetone vapor-polished ABS tensile specimens of 1-, 2- and 4-mm thicknesses produced by material extrusion (FDM). Findings Vapor polishing proves to decrease the power spectral density for surface roughness features larger than 20 µm by a factor of 10× and shows significant improvement in hermeticity based on both perfluorocarbon gross leak and pressure leak tests. However, there is minimal impact on mechanical properties with the thin specimens showing a slight increase in elongation at break but decreased elastic modulus. A bi-exponential diffusion decay model for solvent evaporation suggest a thickness-independent and thickness-dependent time constant with the latter supporting a plasticizing effect on mechanical properties. Originality/value The contributions of this work show vapor polishing can have a substantial impact on the performance for end-use application of ABS FDM components.

Fabrication of microfluidic chips using controlled dissolution of3Dprinted scaffolds

“…[ 38 ] Moreover, the ability of eISR to smooth the surface of 3D printed curved ABS channels greatly enhances the drawback of having void spaces typically existing at the edges of 3D printed layers of ABS using FDM. [ 35,40 ] Finally, eISR could be used to produce round channels with different diameters to compose vasculature systems [ 41 ] in one microfluidic device, which is difficult to fabricate using FDM 3D printers only.…”

Improving Performance of Electrospun Nylon 6,6 Nanofiber Membrane for Produced Water Filtration via Solvent Vapor Treatment

“…This phenomenon occurs as surface tension overpowers surface viscosity due to swelling (vapor is absorbed to the membrane surface). The high peaks of surface roughness will "run" through the valleys driven by the surface tension and hence resulted in a smoother surface [35,36]. Surface roughness plays an important role in controlling the fouling in membrane separation.…”

Effect of protective coatings on the water absorption and mechanical properties of 3D printed PLA

“…The benefits and simplicity of the use of protective coatings on PLA parts are a potential alternative to other chemical treatments that were proposed to sealing FDM components, but with negative consequences on some mechanical properties [26,28,35] especially when thin sections are present on parts [36].…”