Influence of post-treatments on the contact resistance of plasma-sprayed La0.8Sr0.2MnO3 coating on SOFC metallic interconnector

Fabrication of seven cells in single tubular solid oxide fuel cell using multi-pass extrusion process

“…NiO powders were purchased from Junsei Chemical Co. Ltd., Japan, 8YSZ (TZ-8Y) powders were purchased from Tosoh Corporation, Tokyo, Japan and LSM powders were synthesized by a solid state reaction method [7]. NiO-8YSZ anode powders were prepared by a mechanical mixing method.…”

Characterization of yttria-stabilized zirconia films deposited by dip-coating on La0.7Sr0.3MnO3 substrate: Influence of synthesis parameters

“…Small peaks at 21°, 28.1° and 45° may be attributed to La 2 O 3 (JCPDS 22641) formed during severe heat treatment of LSM [15]. The formation of these secondary phases is more pronounced for the samples prepared with lower viscosity.…”

Oxidation and electrical behavior of ferritic stainless steel interconnect with Fe–Co–Ni coating by electroplating

“…The techniques used for coatings on FSS include solegel method [26,27], chemical vapor deposition [28,29], plasma spraying [30], slurry coating [31] and magnetron sputtering [32]. Recently, electrodeposition of metal or alloy coatings followed by subsequent thermal exposure to form spinel coatings directly on the FSS substrates has been considered as an economical and simple technique [33e36] due to its advantages such as better coating-to-substrate adhesion, denser, less porous spinel coatings and good coverage of the electrodeposited coating on almost any substrate surfaces especially for complex-shaped interconnects.…”