Optical fiber plasmonic sensor for the ultrasensitive detection of copper (II) ion based on trimetallic Au@AgPt core-shell nanospheres

Huang, Qing; Zhu, Wenjie; Wang, Yong; Deng, Zhao; Li, Zhi; Peng, Jue; Lyu, Dajuan; Lewis, Elfed; Yang, Minghong

doi:10.1016/j.snb.2020.128480

Cited by 17 publications

(6 citation statements)

References 46 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…A variety of chemical and bioreceptors including noble metal clusters and their composites (Au/Ag), MOFs, dyes, quantum dots, denatured antibodies, etc. have been explored to achieve very high sensitivity and selectivity.…”

Section: Resultsmentioning

confidence: 99%

“…Absorbance-based techniques have several merits including low cost, simpler instrumentation, portability, and the possibility of detecting various contaminants with distinct absorption spectral characteristics. Recently, a variety of absorbance-based FOS copper ion sensors have been reported using different FOS configurations. − Among the variety of FOS platforms, U-bent fiber optic sensors (FOS) have lately been recognized as excellent candidates for ultrasensitive chemical and biosensing applications due to their remarkable evanescent wave excitation and absorbance (EWA) sensitivity. − FOS probes are known to provide 10 times higher EWA sensitivity and RI sensitivity in comparison to straight decladded probes. In addition, they allow the ergonomic design of the probes for the following reasons: (a) the small form-factor of the sensor probe, (b) microfluidics-free dip-type sensing, and (c) feasibility to place a light source and detector side by side at either of the distal ends of the probes …”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Cobalt-Doped ZIF-8 Nanoparticle-Decorated Fiber Optic Sensor for Copper Ion Detection

Menon,

Dutta,

Madaboosi

et al. 2023

ACS Appl. Nano Mater.

View full text Add to dashboard Cite

Copper is a toxic water contaminant; its quantification below the maximum contaminant level (MCL) of 1.3 ppm by a sensitive, fielddeployable sensor becomes critical. Here, the cobalt-doped zeoliticimidazolate framework (Co/ZIF-8) nanomaterial was developed as a novel, highly selective, sensitive, and stable chemoreceptor as an alternative to ZIF-8 for Cu(II) ion detection. A dip-type optical absorption Cu(II) ion sensor was realized by an in situ deposition of Co/ZIF-8 nanoparticles over a highly sensitive U-bent fiber optic sensor (FOS) probe with a remarkable high evanescent wave-based absorption (EWA) sensitivity. The Co/ZIF-8 coated FOS works on the principle of attenuation of the light passing through the FOS by the Co/ZIF-8 nanoparticles due to EWA at 400 nm wavelength upon interaction with Cu(II) ions and increases proportional to the Cu(II) ions concentrations. The interaction of Cu(II) ions with Co/ZIF-8 nanoparticles was extensively characterized with the help of UV− visible absorption, scanning electron microscopy and EDAX analysis, X-ray diffraction, and FTIR absorption spectral analysis. Cu(II) ions were found to replace Zn(II) in the Co/ZIF-8, forming Cu-imidazole complexes over and off the nanoparticles, leaving the surface rich with Co-and Cu-imidazole complexes and thereby altering the optical and morphological properties of the Co/ZIF-8. The sensor demonstrated an excellent dynamic range of 0.05−100 ppm with an experimental LoD of 50 ppb using a simple LEDphotodetector-based setup, selectivity for Cu(II) against 12 other potential interfering metal ions, and a shelf life of at least 3 months. The facile and scalable Co/ZIF-8 deposition process, simpler instrumentation, excellent sensor parameters, and good recovery rates with field water samples make this strategy highly promising for on-site environmental monitoring.

show abstract

Section: Resultsmentioning

confidence: 99%

Section: Introductionmentioning

confidence: 99%

Cobalt-Doped ZIF-8 Nanoparticle-Decorated Fiber Optic Sensor for Copper Ion Detection

Menon,

Dutta,

Madaboosi

et al. 2023

ACS Appl. Nano Mater.

View full text Add to dashboard Cite

show abstract

“…Compared with this detection method, optic-fiber sensors have attracted much attention due to their high sensitivity, compact structure, low cost, fast response，remote measurement capability and anti-electromagnetic interference. Huang et al presented an ultrasensitive localized surface plasmon resonance (LSPR) sensor system based on multimodesinglemode-multimode fiber (MMF-SMF-MMF) structure for the accurate measurement of copper (II) Ion (Cu 2+ ) [5] the results present that when the concentration of Cu 2+ is 0-0.1 mM, the sensitivity could reach 78.03 nm/mM [ 6] ，though the taper-in-taper fiber sensor shows high sensitivity，but will also weaken the mechanical strength of the sensor，so the taper-drawing technique is difficult to ensure excellent consistency in fabrication. Tang et al proposed a long-period grating fiber sensor with the layer-by-layer (LBL) electrostatic assembly technology, Detection of 1.3 mg Cu II L −1 was observed when six bilayers comprised the coating.…”

Section: Introductionmentioning

confidence: 99%

Optical fiber copper (II) ion sensor based on Mach–Zehnder interferometer

Lei¹

2023

Ninth Symposium on Novel Photoelectronic Detection Technology and Applications

View full text Add to dashboard Cite

“…Sung et al [ 42 ] proposed using a high sensitive fiber sensor based on CdSe/ZnS QD for Cu 2+ ion detection via fluorescence quenching, but there is a high temperature cross interference on fluorescence intensity variation. Huang et al [ 43 ] developed an ultra-sensitive optical fiber plasmonic sensor for Cu 2+ detection with a multimode-single-mode-multimode structure which requires complicated fabrication techniques and is also costly. Additionally, Tang et al [ 44 ] proposed a long-period grating fiber sensor for the detection of Cu 2+ with the maximum sensitivity of 26.1265 nm/mM, which is not high enough in practical use.…”

Section: Introductionmentioning

confidence: 99%

A Taper-in-Taper Structured Interferometric Optical Fiber Sensor for Cu2+ ion Detection

Gong

Lei

Wang

et al. 2022

Sensors

View full text Add to dashboard Cite

Copper ion is closely associated with the ecosystem and human health, and even a little excessive dose in drinking water may result in a range of health problems. However, it remains challenging to produce a highly sensitive, reliable, cost-effective and electromagnetic-interference interference-immune device to detect Cu2+ ion in drinking water. In this paper, a taper-in-taper fiber sensor was fabricated with high sensitivity by mode-mode interference and deposited polyelectrolyte layers for Cu2+ detection. We propose a new structure which forms a secondary taper in the middle of the single-mode fiber through two-arc discharge. Experimental results show that the newly developed fiber sensor possesses a sensitivity of 2741 nm/RIU in refractive index (RI), exhibits 3.7 times sensitivity enhancement when compared with traditional tapered fiber sensors. To apply this sensor in copper ions detection, the results present that when the concentration of Cu2+ is 0–0.1 mM, the sensitivity could reach 78.03 nm/mM. The taper-in-taper fiber sensor exhibits high sensitivity with good stability and mechanical strength which has great potential to be applied in the detection of low Cu2+ ions in some specific environments such as drinking water.

show abstract

Optical fiber plasmonic sensor for the ultrasensitive detection of copper (II) ion based on trimetallic Au@AgPt core-shell nanospheres

Cited by 17 publications

References 46 publications

Cobalt-Doped ZIF-8 Nanoparticle-Decorated Fiber Optic Sensor for Copper Ion Detection

Cobalt-Doped ZIF-8 Nanoparticle-Decorated Fiber Optic Sensor for Copper Ion Detection

Optical fiber copper (II) ion sensor based on Mach–Zehnder interferometer

A Taper-in-Taper Structured Interferometric Optical Fiber Sensor for Cu2+ ion Detection

Contact Info

Product

Resources

About