Performance Study of Imitated Syngas in a Dual-Fuel Compression Ignition Diesel Engine

The study investigated the engine performance and emission using biodiesel from soybean oil and waste cooking oil. The fuel properties of these biodiesels were determined using ASTM D6751and EN 14214 standards. The fuels were tested in a multi-cylinder diesel engine with an electromagnetic dynamometer and a 5-gas analyser was used for emission analysis. The result shows that the thermal performance of the engine slightly decreases with increase of the biodiesel blends ratio (i.e. B5, B10, B15, B20 and B50). On the other hand, emission decreases with the increase of biodiesel blends. The reduction in emissions was different for both biodiesels. Waste oil biodiesel showed better trends of emissions reduction with increase of the biodiesel percentage compared with soybean biodiesel. The brake specific fuel consumption (BSFC) of both biodiesels is (6.05%, 9.13%, 12.36% and 18.57% for soybean) and (8.17%, 11.40%, 17.71% and 14.96% for waste cooking oil) higher than diesel, respectively. However, soybean biodiesel consumed less fuel and produced more power and torque compared to waste oil biodiesel. The study concluded that B10 soybean biodiesel blend produced more consistent and expected results than waste oil biodiesel from the performance and emission point of view.

Section: Brake Specific Fuel Consumptionsupporting

confidence: 55%

Comparative study of diesel engine performance and emission with soybean and waste oil biodiesel fuels

Azad¹,

Rasul²,

Giannangelo³

et al. 2015

“…It was estimated that there will be a phenomenal rise in energy consumption in the next three to four decades and expected that 2.3 billion population increase will further worsen the energy scenario, reaching 66% of the global population by 2030 [1][2][3][4]. This exorbitant rise in the power consumption is expected to be concentrated in the Latin America, Africa and the urban pockets of Asia.…”

Section: Introductionmentioning

confidence: 99%

Study of the performance and emission characteristics for a dual fuel powered single cylinder diesel engine

Dubey¹,

Gupta²

2022

In the present study, the performance of a new combination of biofuels jatropha biodiesel and turpentine oil for a diesel engine with a view to eliminate dependency on fossil fuel was observed. Jatropha biodiesel and turpentine oil are a high and low viscosity fuel combination with comparable heating values to that of diesel; this makes them conducive for in a diesel engine. The extensive experimental work was carried out on a Kirloskar make-single cylinder, constant speed, four strokes, 661cc diesel engine to examine the combustion performance and emission characteristics using the jatropha methyl-ester with turpentine oil and pure diesel. The engine was fuelled with the jatropha methyl-ester with turpentine oil (50% -50% on a volume basis) blend run on different loading conditions from no load, 35%, 65%, and full load. The blend of a dual biofuel was prepared with the help of a magnetic stirrer at 40°C in the presence of a surfactant span 80. The dual fuel blend was found to be superior to the diesel fuel in all aspects such as performance and emissions. In a further full load condition, a decrease of 2.9% in the brake thermal efficiency and reduction of 41.6%, 3%, and 4.43% in CO, NOx and CO2 respectively were recorded while HC was found to increased 29.31%.

“…The primary focus has been on the use of biodiesel in diesel engines [1][2][3][8][9][10][11]. The compatible physiochemical properties of biodiesel to diesel fuel have allowed up to 20% blending of biodiesel with petroleum diesel for the application in diesel engines without any modification [12][13][14][15][16][17].…”

Section: Introductionmentioning

confidence: 99%

Performance and emission characteristics of micro gas turbine engine fuelled with bioethanol-diesel-biodiesel blends

Saifuddin¹,

Refal²,

Palanisamy³

2017

Biodiesel is receiving increasing attention as an alternative fuel due to the ever-growing demand for energy. However, the inferior physiochemical properties of biodiesel render it incompatible for gas turbine application, which needs to meet the standard requirement of gas turbine fuel accordance to ASTM D2880. In this quest, the biodiesel-dieselbioethanol blends might be a good option. In this paper, the research work was carried out to study experimentally the performance and exhaust emission characteristics of a 25kW micro gas turbine engine (Capstone Model C30) fuelled with biodiesel-dieselbioethanol blends. The assessment on the improved fuel properties of biodiesel by blending with bio-ethanol had shown more superior atomisation characteristics performance compared to unmodified biodiesel. Moreover, the performance test in the micro gas turbine was limited up to 20% blend of biofuel, which showed improved thermal efficiency during the test. Subsequently, the emission test carried out in this work also showed significant enhancement in emissions, except nitrogen oxides (NOx) which contributed to the higher formation in comparison with the distillate diesel. Finally, B80E20 (80:20 of biodiesel-bioethanol) was proposed to be selected as an ideal blended fuel ratio to be applied in micro gas turbine engine due to its adaptability to replace diesel fuel, while showed better performance and emission properties as compared to the pure petroleum diesel.