Sintesis dan Uji FTIR Barium M-Hexaferrite dengan Doping Logam Mn

Doyan, Aris; Khalilurrahman, Khalilurrahman; Susilawati, Susilawati

doi:10.29303/jpft.v1i4.264

Cited by 4 publications

(6 citation statements)

References 3 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The synthesis of BaFe12O19 using Cu and Ni doping unveiled by the formula BaFe12-2xCuxNixO19 can be carried out using several methods: the coprecipitation method [11], the sol-gel method [12], the mechanical alloying method [13], and the mechanical milling method [14]. BaFe12-2xCuxNixO19 was synthesized using natural iron sand from the Ijobalit Beach, Labuhan Haji District, East Lombok.…”

Section: Introductionmentioning

confidence: 99%

Synthesis BaFe₁₂O₁₉ based on natural iron sand with Cu and Ni doping using coprecipitation method

Elinda

Susilawati

Kosim

et al. 2022

J. Phys.: Conf. Ser.

View full text Add to dashboard Cite

Synthesis of BaFe12O19 based on natural iron sand with Cu and Ni doping using the coprecipitation method has been done. This research was conductedat the Chemistry Laboratory, Faculty of Teacher Training and Education, Mataram University. The synthesis was carried out through the variation of doping ions and calcination temperature. The concentration of doping ion used is x = 0.0; 0.4; 0.8; and 1.0 with variations in calcination temperature of 200, 600, and 1000 0C. The materials used are BaCO3, Fe3O4, CuSO4, and NiCl2.6H2O powder. This synthesis process aims to obtain BaFe12-2xCuxNixO19 powder that will later be used as a microwave absorbent material. To obtain sample powder of BaFe12-2xCuxNixO19, thisresearch is carried out through three stages: natural sand separation, magnetic minerals separation, and synthesisand calcination. The separation is to attach magnetic materials from the sand using a permanent magnet. After that, the magnetic mineral is detached from the separated sand to obtain Fe3O4 powder, which will later be used for synthesis. The results of synthesis and calcination showed that the more doping ions applied, the more concentrated the resulting powder. Similarly, according to the temperature variation, the higher the temperature, the more black the sample powder is.

show abstract

Section: Introductionmentioning

confidence: 99%

Synthesis BaFe₁₂O₁₉ based on natural iron sand with Cu and Ni doping using coprecipitation method

Elinda

Susilawati

Kosim

et al. 2022

J. Phys.: Conf. Ser.

View full text Add to dashboard Cite

show abstract

“…Lombok Island has a variety of sand colors caused by geological activity (Doyan et al, 2015). The difference in the sand is spread throughout the island, starting from the dark in the northern part of the island, to white in the southern part (Doyan et al, 2020).…”

Section: Introductionmentioning

confidence: 99%

“…Therefore, microwave absorption technology is needed. One of the studies in the field of science and technology that developed at the end of this decade answered the problem, namely research on magnetic material (Doyan et al, 2015).…”

Section: Introductionmentioning

confidence: 99%

Analysis Magnetic Mineral Content of Natural Iron Sand in Beach Island Lombok as Basic Materials of Micro Wave Absorbers

Susilawati¹,

Doyan

Hadisaputra

2022

jppipa, pendidikan ipa, fisika, biologi, kimia

View full text Add to dashboard Cite

This study aims to analyze the content of the magnetic mineral compound of natural iron sand on the beach of Lombok Island. This study uses the experimental method by taking primary data which is carried out in three locations, namely at Ijobalit Beach (East Lombok), Cemara Beach (West Lombok), and Telindung Beach (East Lombok). The study stage begins with a separation of natural iron sand, then a magnetic mineral separation is carried out to obtain Fe3O4 powder. The last stage is testing the Fe content using AAS (atomic absorption spectrophotometry). The research results were obtained by the percentage of magnetic mineral content from Ijobalit beach sand, Cemara Beach, and Telindung Beach respectively 93.56, 72.99, and 87.00%. The results showed that natural iron sand from Ijobalit beach had great potential to be used as a basic material for making microwave absorbers.

show abstract

“…Therefore, it is very suitable for technological equipment in a reasonably wide range [6]. In addition, Barium hexaferrite, which has lossy material properties, has a high dielectric loss and magnetic loss factor, so the material has good properties for electromagnetic wave absorption [7]. However, Barium hexaferrite magnetic material only has a relatively small and district width of microwave absorption frequency.…”

mentioning

confidence: 99%

“…This research uses a combination of transition metal elements Mn-Cr to form the BaFe12-2xCrxMnxO19 phase because these two elements have a radius and ionic configuration similar to Fe 3+ . The electrical and magnetic properties of the substitution of Barium M-Hexaferrite depend on the synthesis process [7].…”

mentioning

confidence: 99%

Synthesis of BaFe12-xCrxMnxO19 material based on Telindung beach iron sand using coprecipitation method

Fatari

Doyan

Makhrus

et al. 2022

J. Phys.: Conf. Ser.

View full text Add to dashboard Cite

The production of BaFe12-xCrxMnxO19 material has been carried out based on iron sand at Telindung Beach, East Lombok Regency, using the coprecipitation method. The manufacture of BaFe12-xCrxMnxO19 material has three stages: the separation stage, the magnetic material separation stage, and the synthesis stage. The separation stage aims to separate the material from non-magnetic materials to obtain the maximum total Fe content. The results obtained are 43.50 grams of magnetic material from 50 grams of natural sand using a permanent magnet. The next stage is separating the magnetic materialused as the basic ingredients in the synthesis of BaFe12-xCrxMnxO19. The fundamentalcomponents used in the synthesis process were BaCO3, Fe3O4 obtained from the separation, MnCl2 and CrO3 as doping, NH4OH as a precipitate, and 37% HCl as a solvent. The dissolution process was carried out using a hot plate magnetic stirrer for 30 minutes at 80°C. Synthesis Barium M-Hexaferrite based on natural iron sand by using doping ion variations x= 0.0; 0.4; 0.8; 1.0 and calcination temperature of 200 °C, 600 °C and 1000 °C. The synthesis results made the colour change of BaFe12-xCrxMnxO19 powder darker. This happens because the higher the mole fraction of doping used, the darker the powder obtained. Moreover, the darker colour of the powder indicates that the solvent has evaporated due to the calcination process.

show abstract

Sintesis dan Uji FTIR Barium M-Hexaferrite dengan Doping Logam Mn

Cited by 4 publications

References 3 publications

Synthesis BaFe₁₂O₁₉ based on natural iron sand with Cu and Ni doping using coprecipitation method

Synthesis BaFe₁₂O₁₉ based on natural iron sand with Cu and Ni doping using coprecipitation method

Analysis Magnetic Mineral Content of Natural Iron Sand in Beach Island Lombok as Basic Materials of Micro Wave Absorbers

Synthesis of BaFe12-xCrxMnxO19 material based on Telindung beach iron sand using coprecipitation method

Contact Info

Product

Resources

About

Sintesis dan Uji FTIR Barium M-Hexaferrite dengan Doping Logam Mn

Cited by 4 publications

References 3 publications

Synthesis BaFe12O19 based on natural iron sand with Cu and Ni doping using coprecipitation method

Synthesis BaFe12O19 based on natural iron sand with Cu and Ni doping using coprecipitation method

Analysis Magnetic Mineral Content of Natural Iron Sand in Beach Island Lombok as Basic Materials of Micro Wave Absorbers

Synthesis of BaFe12-xCrxMnxO19 material based on Telindung beach iron sand using coprecipitation method

Contact Info

Product

Resources

About

Synthesis BaFe₁₂O₁₉ based on natural iron sand with Cu and Ni doping using coprecipitation method

Synthesis BaFe₁₂O₁₉ based on natural iron sand with Cu and Ni doping using coprecipitation method